STM8S003F3 STMicroelectronics, STM8S003F3 Datasheet - Page 77

• Manufacturer Part Number: STM8S003F3
• Description: Value line, 16 MHz STM8S 8-bit MCU, 8 Kbytes Flash, 128 bytes data EEPROM
• Manufacturer: STMicroelectronics

Specifications of STM8S003F3

• Program Memory: 8 Kbytes Flash; data retention 20 years at 55 °C after 100 cycles
• Data Memory: 128 bytes of true data EEPROM; endurance up to 100 000 write/erase cycles
• Ram: 1 Kbytes
• Advanced Control Timer: 16-bit, 4 CAPCOM channels, 3 complementary outputs, dead-time insertion and flexible synchronization

STM8S003K3 STM8S003F3
9.3.8
The reset network shown in the following figure protects the device against parasitic resets.
The user must ensure that the level on the NRST pin can go below V
#unique_55/CD662
For power consumption sensitive applications, the external reset capacitor value can be
reduced to limit the charge/discharge current. If NRST signal is used to reset external circuitry,
attention must be taken to the charge/discharge time of the external capacitor to fulfill the
external devices reset timing conditions. Minimum recommended capacity is 10 nF.
SPI serial peripheral interface
Unless otherwise specified, the parameters given in the following table are derived from tests
performed under ambient temperature, f
t
Refer to I/O port characteristics for more details on the input/output alternate function
characteristics (NSS, SCK, MOSI, MISO).
MASTER
= 1/f
Figure 36: Typical NRST pull-up current vs V
MASTER
(optional)
External
circuit
reset
.
), otherwise the reset is not taken into account internally.
Figure 37: Recommended reset pin protection
DocID018576 Rev 2
0.1 µF
NRST
MASTER
V DD
R PU
frequency and V
Filter
DD
Internal reset
@ 4 temperatures
DD
Electrical characteristics
supply voltage conditions.
STM8
IL
(NRST) max. (see
77/99