STR711FR0 STMicroelectronics, STR711FR0 Datasheet - Page 33

• Manufacturer Part Number: STR711FR0
• Description: ARM-Based Flash microcontrollers with USB
• Manufacturer: STMicroelectronics

Specifications of STR711FR0

• 5 Power Saving Modes: SLOW, WAIT, LPWAIT, STOP and STANDBY modes
• Conversion Range: 0 to 2.5 V

STR71xF
4
4.1
4.1.1
4.1.2
4.1.3
4.1.4
4.1.5
Electrical parameters
Parameter conditions
Unless otherwise specified, all voltages are referred to V
Minimum and maximum values
Unless otherwise specified the minimum and maximum values are guaranteed in the worst
conditions of ambient temperature, supply voltage and frequencies by tests in production on
100% of the devices with an ambient temperature at T
selected temperature range).
Data based on characterization results, design simulation and/or technology characteristics
are indicated in the table footnotes and are not tested in production. Based on
characterization, the minimum and maximum values refer to sample tests and represent the
mean value plus or minus three times the standard deviation (mean±3Σ).
Typical values
Unless otherwise specified, typical data are based on T
3.0V≤V
are not tested.
Typical ADC accuracy values are determined by characterization of a batch of samples from
a standard diffusion lot over the full temperature range, where 95% of the devices have an
error less than or equal to the value indicated (mean±2Σ)
Typical curves
Unless otherwise specified, all typical curves are given only as design guidelines and are
not tested.
Loading capacitor
The loading conditions used for pin parameter measurement are shown in
Pin input voltage
The input voltage measurement on a pin of the device is described in
Figure 9.
L
=50pF
33
≤3.6V voltage range) and V
Pin loading conditions
STR7 PIN
18
=1.8V. They are given only as design guidelines and
Figure 10. Pin input voltage
A
=25°C and T
A
SS
=25°C, V
.
.
V
IN
33
=3.3V (for the
A
Electrical parameters
=T
Figure
A
max (given by the
STR7 PIN
Figure
10.
9.
33/78