ST7MC2R6 STMicroelectronics, ST7MC2R6 Datasheet - Page 165

• Manufacturer Part Number: ST7MC2R6
• Description: 8-BIT MCU WITH NESTED INTERRUPTS, FLASH, 10-BIT ADC,BRUSHLESS MOTOR CONTROL, 5 TIMERS, SPI, LINSCI(TM)
• Manufacturer: STMicroelectronics

Specifications of ST7MC2R6

• Hdflash Endurance: 100 cycles, data retention
• Clock Sources: crystal/ceramic resonator oscillators and by-pass for external clock, clock security system.
• Four Power Saving Modes: Halt, Active-Halt, Wait and Slow
• Main Clock Controller With: Real time base, Beep and Clock-out capabilities
• Two 16-bit Timers With: 2 input captures, 2 output compares, external clock input, PWM and pulse generator modes
• 8-bit Pwm Auto-reload Timer With: 2 input captures, 4 PWM outputs, output compare and time base interrupt, external clock with event detector

MOTOR CONTROLLER (Cont’d)
10.6.6.13 Encoder Mode (IS[1:0] = 11)
Figure 90
ard digital incremental encoder and associated in-
formation:
Figure 89. Tacho Capture events configured by the TES[1:0] bits
Figure 90. Incremental Encoder output signals and derived information
– Two 90° phased square signals with variable
– Clock derived from incoming signal edges,
– Direction information determined by the rela-
frequency proportional to the speed; they
must be connected to MCIA and MCIB input
pins,
tive phase shift of input signals ( + or -90°).
Capture
Encoder
Tacho
inputs
(EDIR bit)
Direction
shows the signals delivered by a stand-
Encoder
Clock
Tacho
input
MCIA
MCIB
The Incremental Encoder Interface block aims at
extracting these signals. As input logic is both ris-
ing and falling edge sensitive (independently from
TES[1:0] bits setting), resulting clock frequency is
four times the one of the input signals, thus in-
creasing resolution for measurements.
It may be noticed that Direction bit (EDIR bit in
MCRC register) is read only and that it does’nt af-
fect counting direction of clocked timer (cf
). As a result, one cannot extract position informa-
tion from encoder inputs during speed reversal.
Sampling of MCIA to determine direction
ST7MC1xx/ST7MC2xx
TES[1:0]=11
TES[1:0]=01
TES[1:0]=10
Section
165/309
1