ST72324BK4-Auto STMicroelectronics, ST72324BK4-Auto Datasheet - Page 74

• Manufacturer Part Number: ST72324BK4-Auto
• Description: 8-bit MCU for automotive, 3.8 to 5.5V operating range with 16 Kbyte Flash, 10-bit ADC, 4 timers, SPI, SCI
• Manufacturer: STMicroelectronics

Specifications of ST72324BK4-Auto

• Hdflash Endurance: 100 cycles, data retention 20 years
• Clock Sources: crystal/ceramic resonator oscillators, internal RC oscillator and external clock input
• 4 Power Saving Modes: Slow, Wait, Active Halt, and Halt

On-chip peripherals
10.3
10.3.1
10.3.2
74/198
16-bit timer
Introduction
The timer consists of a 16-bit free-running counter driven by a programmable prescaler.
It may be used for a variety of purposes, including pulse length measurement of up to two
input signals (input capture) or generation of up to two output waveforms (output compare
and PWM).
Pulse lengths and waveform periods can be modulated from a few microseconds to several
milliseconds using the timer prescaler and the CPU clock prescaler.
Some ST7 devices have two on-chip 16-bit timers. They are completely independent, and
do not share any resources. They are synchronized after a MCU reset as long as the timer
clock frequencies are not modified.
This description covers one or two 16-bit timers. In ST7 devices with two timers, register
names are prefixed with TA (Timer A) or TB (Timer B).
Main features
●
●
●
●
●
●
●
●
●
The timer block diagram is shown in
c. Some timer pins may not be available (not bonded) in some ST7 devices. Refer to
When reading an input signal on a non-bonded pin, the value will always be ‘1’.
Programmable prescaler: f
Overflow status flag and maskable interrupt
External clock input (must be at least four times slower than the CPU clock speed) with
the choice of active edge
1 or 2 output compare functions each with:
–
–
–
–
1 or 2 input capture functions each with:
–
–
–
–
Pulse width modulation mode (PWM)
One pulse mode
Reduced power mode
5 alternate functions on I/O ports (ICAP1, ICAP2, OCMP1, OCMP2, EXTCLK)
2 dedicated 16-bit registers
2 dedicated programmable signals
2 dedicated status flags
1 dedicated maskable interrupt
2 dedicated 16-bit registers
2 dedicated active edge selection signals
2 dedicated status flags
1 dedicated maskable interrupt
Doc ID13466 Rev 4
CPU
divided by 2, 4 or 8
Figure
34.
Section 2: Pin
ST72324B-Auto
description.
(c)