968137-5 TE Connectivity, 968137-5 Datasheet - Page 14

• Manufacturer Part Number: 968137-5
• Manufacturer: TE Connectivity

Specifications of 968137-5

• Wire/cable Type: FLR (Thin Walled Cable)
• Product Type: Contact
• Termination Method To Wire/cable: Crimp
• Sealed: No
• Insulation Diameter (mm [in]): 2.20-3.00 [.086-.118]
• Cable Type: FLR (Thin Walled Cable)
• Tab Width (mm [in]): 2.79 [0.11]
• Wire Range (mm [awg]): 1.00-2.50² [17-13]
• Staggered Centerline: Without
• Wire Type: Stranded
• Mates With Centerline: 5.08 x 5.08 [.200 x .200]
• Contact Type: Tab
• Tab Contact Size: 2.8
• Contact Finish: Gold
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Not relevant for lead free process
• Rohs/elv Compliance History: Always was RoHS compliant
• Applies To: Wire/Cable
• Packaging Method: Strip
• Packaging Quantity: 4,000

Rev. B
4.5 Environmentals
TEST DESCRIPTION
Electrical stress test
Salt fog in changing
Dynamical
Environmental
climates
mechanical load
simulation
-20
-40
80
60
40
20
0
0
After the entire test, the total
After the entire test, the contact
200% of the original value for
300% of the original value for tin-
The contact resistance increases
Maximum discontinuity duration:
t
After the entire test, the contact
200% of the original value for
350% for tin-plated contacts.
With the rated current applied for
resistance (contact + crimp
resistance) increases by not more
than 200% of the original value.
resistance increases by not more
than:
gold-plated contacts;
plated contacts.
by not more than 200% of the
original value. There is no
mechanical damage.
resistance in the mated condition
increases by not more than:
gold-plated contacts;
15 minutes, the current heating
may not be more than 20 K
higher than in the new condition.
1 µs
Temperature/ Current Changing Cycle
REQUIREMENTS
1
2
Loading
(Nominal Current)
Time / h
3
Test conditions and procedure
see section 4.6.1
Temperature: -40 C to +80 C, cycle duration 6h
Current during warm phase: see the derating curves at 80 C
Test conditions
Test in mated state.
Procedure
See section 4.6.1 or 4.6.2.
Monitor for discontinuities during the entire test duration.
Test in mated state.
Procedure: see section 4.6.1 or 4.6.2.
Test in accordance with DIN IEC 68 P.2-6
Test conditions
Test in mated state.
Procedure
See section 4.6.1 or 4.6.2.
ambient temperature.
4
5
PROCEDURE
6
108-18476-1
14
of
25