STM6710 STMicroelectronics, STM6710 Datasheet - Page 12

• Manufacturer Part Number: STM6710
• Description: Microprocessor Supervisors and Reset ICs, Reset ICs
• Manufacturer: STMicroelectronics

Operation
2.3
2.4
12/22
Unused inputs
Connect unused monitor inputs to a supply voltage greater in magnitude than their specified
threshold voltages. For unused VxIN adjustable inputs connect a 1 M ohm resistor between
unused input and V2IN or (V
(device power supply pin). Do not connect unused monitor inputs to ground or allow them to
float.
Adding manual reset capability
Figure 8
Depressing the push button switch short circuits the analog input to ground and initiates a
RESET pulse. The switch must be open for at least 140 ms in order to de-assert the
RESET output. No external switch debounce is required. A small capacitor may be used to
improve noise immunity.
Figure 8.
shows a circuit which can be used to add manual reset capability for the STM6710.
Adding manual reset capability for STM6710 input
Figure 8
R1
CC
Doc ID 16887 Rev 1
) to limit the bias current. Use V2IN for normal operation
below shows the addition of the manual reset capability.
R2
V1IN
V2IN
V3IN
V4IN
(ADJUSTABLE
INPUT)
GND
RESET
STM6700, STM6710
AM04624v1