DS2406 Maxim, DS2406 Datasheet - Page 25

• Manufacturer Part Number: DS2406
• Description: The DS2406 Dual Addressable Switch Plus Memory offers a simple way to remotely control a pair of open drain transistors and to monitor the logic level at each transistor's output via the 1-Wire® bus for closed loop control
• Manufacturer: Maxim

READ/WRITE TIMING DIAGRAM (continued) Figure 15
Read-data Time Slot
PROGRAM PULSE
To copy data from the 8-bit scratchpad to the EPROM data or status memory, a program pulse is applied
to the data line after the bus master has confirmed that the CRC for the current byte is correct. During
programming, the bus master controls the transition from a state where the data line is idling high via the
pull-up resistor to a state where the data line is actively driven to a programming voltage of 12V
providing a minimum of 10mA of current to the DS2406. This programming voltage (Figure 16) should
be applied for 480µs, after which the bus master should return the data line to the idle high state. Note
that due to the high voltage programming requirements for any 1-Wire EPROM device, it is not possible
to multi-drop non-EPROM based 1-Wire devices with the DS2406 during programming. An internal
diode within the non-EPROM based 1-Wire devices will attempt to clamp the data line at approximately
8V and could potentially damage these devices.
* The optimal sampling point for the master is as close as possible to the end time of the 15 μ s t
V
period without exceeding t
of time for the pull-up resistor to recover the line to a high level. For a Read-zero time slot it
ensures that a read will occur before the fastest 1-Wire devices(s) release the line (t
PULLUP MIN
V
V
PULLUP
V
IL MAX
IH MIN
0V
RESISTOR
MASTER
DS2406
t
LOWR
t
SU
RDV
. For the case of a Read-one time slot, this maximizes the amount
t
RDV
Sampling Window
60 µs ≤ t
2 µs ≤ t
0 ≤ t
5 µs ≤ t
t
t
RDV
SU
< 2 µs
RELEASE
Master
= 15 µs
LOWR
REC
SLOT
t
SLOT
25 of 32
<
< 45 µs
< 15 µs
∞
< 120 µs
t
RELEASE
t
REC
RELEASE
= 0).
RDV