HY27UF081G2A Hynix Semiconductor, HY27UF081G2A Datasheet - Page 17

• Manufacturer Part Number: HY27UF081G2A
• Description: 1gb Nand Flash
• Manufacturer: Hynix Semiconductor

HY27UF(08/16)1G2A Series
1Gbit (128Mx8bit / 64Mx16bit) NAND Flash
4. OTHER FEATURES
4.1 Data Protection for Power on/off Sequence
The device is designed to offer protection from any involuntary program/erase during power-transitions. An internal
voltage detector disables all functions whenever Vcc is below about 2.0V (3.3V version). WP pin provides hardware
protection and is recommended to be kept at VIL during power-up and power-down. A recovery time of minimum 10us
is required before internal circuit gets ready for any command sequences as shown in Figure 24. The two-step com-
mand sequence for program/erase provides additional software protection.
If the power is dropped during the ready read/write/erase operation, Power protection function may not guaranteed
the data. Power protection function is only available during the power on/off sequence.
4.2 Ready/Busy.
The device has a Ready/Busy output that provides method of indicating the completion of a page program, erase,
copy-back, cache program and random read completion. The R/B pin is normally high and goes to low when the device
is busy (after a reset, read, program, erase operation). It returns to high when the P/E/R controller has finished the
operation. The pin is an open-drain driver thereby allowing two or more R/B outputs to be Or-tied. Because pull-up
resistor value is related to tr(R/B) and current drain during busy (Ibusy), an appropriate value can be obtained with
the following reference chart (Figure 25). Its value can be determined by the following guidance.
Rev 0.4 / Jun. 2007
17