TSS463C ATMEL Corporation, TSS463C Datasheet - Page 49

• Manufacturer Part Number: TSS463C
• Description: Van Data Link Controller With Serial Interface
• Manufacturer: ATMEL Corporation

Figure 33. Disable Channel After Rearbitrate
In this case, the TSS463C completes the current attempt (Ch8) and lets the transmission go into the new channel (Ch5 if
validated), otherwise it stops all attempts on the current channel.
Abort
7601B–AUTO–02/06
Delay
Viol
An abort command is dedicated to channels already enabled in transmission or in in-
frame response. For example, this command can be used to break the retry procedure
on one channel.
Abort channel is done by setting the Error bit (CHER) in the Message Length and Status
Register (base_address + 0x02). This command is taken into account if the channel
aborted is not transmitted. When this abort command is really done, the TSS463C set to
1 the Transmitted bit (CHTx) of the Message Length and Status Register.
The abort mechanism is integrated into the transmit function. This mainly means, abort,
priority and retries live together in the transmit function.
(Retries - 1)
(1) The disable is applied setting the CHTx/Ch8 bit to 1.
KO
OK
(not seen by application)
Ex: ACK Error
Second attempt Xmit Ch5
Set CHTx/Ch5 & IT TOK
Delay
Viol
EOF+IFS
stand-by
Set CHER & CHTx /Ch5,
Ex: set ACKE status bit
and set IT TE
EOF+IFS: 8 + 4 T imeslots
Delay Viol: 12 T imeslots
Delay
Viol
stand-by
TSS463C
49