MC56F8347 Freescale Semiconductor, Inc, MC56F8347 Datasheet - Page 2
![no-image](/images/manufacturer_photos/0/2/263/freescale_semiconductor__inc_sml.jpg)
MC56F8347
Manufacturer Part Number
MC56F8347
Description
56f8300 16-bit Digital Signal Controllers
Manufacturer
Freescale Semiconductor, Inc
Datasheet
1.MC56F8347.pdf
(172 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
MC56F8347MPYE
Manufacturer:
Freescale Semiconductor
Quantity:
10 000
Company:
Part Number:
MC56F8347VPYE
Manufacturer:
Freescale Semiconductor
Quantity:
135
Company:
Part Number:
MC56F8347VPYE
Manufacturer:
Freescale Semiconductor
Quantity:
10 000
Part Number:
MC56F8347VPYE
Manufacturer:
FREESCALE
Quantity:
20 000
Company:
Part Number:
MC56F8347VVFE
Manufacturer:
Freescale Semiconductor
Quantity:
10 000
Please see http://www.freescale.com for the most current data sheet revision.
2
Rev 0
Rev 1.0
Rev 2.0
Rev 3.0
Rev 4.0
Rev 5.0
Rev 6.0
Rev 7.0
Rev 8.0
Rev 9.0
Rev 10.0
Rev. 11
Version History
Initial release
Fixed typos in Section 1.1.3, Replace any reference to Flash Interface Unit with Flash Module,
corrected pin number for D14 in
thermal numbers for 160 LQFP in
corrected temperature range in
and new graphs in
Clarification to
numbers in
Added 56F8147 information; edited to indicate differences in 56F8347 and 56F8147.
Reformatted for Freescale look and feel. Updated Temperature Sensor and ADC tables, then
updaated balance of electrical tables for consistency throughout the family. Clarified I/O power
description in
Correcting
Added output voltage maximum value and note to clarify in
expectancy note, since life expectancy is dependent on customer usage and must be
determined by reliability engineering. Clarified value and unit measure for Maximum allowed P
in
Added new RoHS-compliant orderable part numbers in
Added 160MAPBGA information, TA equation updated in
throughout data sheet
Updated
Deleted formula for Max Ambient Operating Temperature (Automotive) and Max Ambient
Operating Temperature (Industrial) and corrected Flash Endurance to 10,000 in
Added RoHS-compliance and “pb-free” language to back cover.
Corrected
Updated JTAG ID in
Clarified external reference crystal frequency for PLL in
value to 8.4MHz.
Replaced “Tri-stated” with an explanation in State During Reset column in
• Added the following note to the description of the TMS signal in
Note:
• Added the following note to the description of the TRST signal in
Note:
environment, TRST may be tied to V
Table
Always tie the TMS pin to V
For normal operation, connect TRST directly to V
10-3. Corrected note about average value for Flash Data Retention in
Table 10-24
Section 6.4
Figure 4-1
Table
Table
Document Revision History
Table
56F8347 Technical Data, Rev.11
10-5. Removed text and Table 10-2; replaced with note to
Figure
2-2, added note to
Section
10-23, corrected Digital Input Current Low (pull-up enabled)
to reflect new value for maximum Uncalibrated Gain Error
Boot Flash Start = $02_0000
title (from Operation Mode Register to Operating Mode Register).
10-22.
6.5.4. Added information/corrected state during reset in
Table
Table
SS
Table
DD
Description of Change
through a 1K resistor.
through a 2.2K resistor.
10-14; added ADC calibration information to
2-2, added note to Vcap pin in
Table 10-7
10-4,removed unneccessary notes in
and clarified
SS
Table
. If the design is to be used in a debugging
Table 10-14
Table 10-4
Table
13-1.
Section
10-1; also removed overall life
Table
Table
by increasing maximum
and additional minor edits
Table
Freescale Semiconductor
12.3.
2-2:
2-2:
Table
2-2, corrected
Table
Table
Table
Table
2-2.
Table 10-24
10-1.
Table
10-13;
10-4.
Preliminary
10-4.
2-2.
D