USB97C100 Standard Microsystems Corporation, USB97C100 Datasheet - Page 50

• Manufacturer Part Number: USB97C100
• Description: USB97C100 Multi-endpoint Usb Peripheral Controller(not Recommended For Designs)
• Manufacturer: Standard Microsystems Corporation

SMSC DS – USB97C100
BIT
7
6
5
4
3
2
1
0
(0x7F98 - RESET=0x40)
EN_EXTFRAME
SIE_SUSPEND
USB_RESUME
SIE_RESUME
RST_FRAME
USB_RESET
SIE_CONFIG
RST_SIE
NAME
FSEN
Table 85 - SIE Configuration Register
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R
R
This bit indicates that the USB97C100 supports 12Mbps USB
data rates. This bit must be set to a one ‘1’ for normal
operation.
1 = Resets the SIE
1 = Clears FRAMEL and Bit 0 through 2 of FRAMEH
Extended Frame Count Enable. Expands the Frame count
from 11 bits to 16 bits for 8051 use.
0 = bits 7-3 of FRAMEH are driven to 0.
1 = Bits 7-3 of FRAMEH count 1-0 transitions of bit 2 in
FRAMEH.
1 = Forces the SIE into USB Suspend Mode. The MCU must
determine that Suspend must be entered.
1 = Forces the SIE to transmit Resume signaling on the line.
1 = Indicates Resume signaling has been detected on the line
while in the Suspend State. This signal causes a Resume
Power Management interrupt).
1 = Indicates that the USB line is being reset. Asserted when
SE0 is present on the bus for 32 or more 12Mbps bit times.
This causes a USB_RESET Power management interrupt.
Page 50
SIE CONFIGURATION REGISTER
DESCRIPTION
Rev. 01/03/2001