TMC2005-JT SMSC Corporation, TMC2005-JT Datasheet - Page 21

no-image

TMC2005-JT

Manufacturer Part Number
TMC2005-JT
Description
ARCNET 5 Port HUB Controller
Manufacturer
SMSC Corporation
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
TMC2005-JT
Manufacturer:
SMSC
Quantity:
101
Part Number:
TMC2005-JT
Manufacturer:
Standard
Quantity:
500
When using the TMC2005 at data rate 2.5Mbps or lower, it is not necessary to use internal PLL. Leave the loop filter
pins (RO, LP) open and connect AGS to the Ground. The pins for the analog power supply (AVSS, AVDD) may
connect to digital power supply. When using the TMC2005 at data rate 5Mbps or higher, the internal PLL has to be
used as a clock multiplier. PCB layout must follow the guidelines at Figure 10, refer to Notes 1 through 5.
Note 1: Prohibit the patterns for LP and RO from occupying the area of digital power supply. Use the area of analog
Note 2: Encircle the pattern between LP, RO and AGS with wide pattern of analog ground.
Note 3: Connect the analog power supply “VAA” with 0.1 uF condenser (a) with in 1/8 inch (~ 3.2mm) from VAA pin.
Note 4: In order to filter the jitter of low frequency, connect a 10 uF condenser (b) in parallel with the condenser (a).
Note 5: Place 0.1 uF bypass condenser (c) within ¼ inch (~ 6.4mm) from VDD3 and VSS3. Connect the ground side
SMSC TMC2005-JT
power supply between VAA and AVSS.
of a condenser (c) at the place (*) where AVSS returns to GND plane.
CONNECTING THE TMC2005 WITH INTERNAL PLL
FIGURE 10 - PLL PATTERN LAYOUT
DATASHEET
Page 21
ARCNET 5 Port HUB Controller
Revision 1.0 (01-30-06)
Datasheet

Related parts for TMC2005-JT