LM3S8933 Luminary Micro, Inc, LM3S8933 Datasheet - Page 169

• Manufacturer Part Number: LM3S8933
• Description: Lm3s8933 Arm Microcontroller
• Manufacturer: Luminary Micro, Inc

9
9.1
July 25, 2008
General-Purpose Input/Outputs (GPIOs)
The GPIO module is composed of seven physical GPIO blocks, each corresponding to an individual
GPIO port (Port A, Port B, Port C, Port D, Port E, Port F, and Port G, ). The GPIO module supports
6-36 programmable input/output pins, depending on the peripherals being used.
The GPIO module has the following features:
■
■
■
■
■
Functional Description
Important:
Each GPIO port is a separate hardware instantiation of the same physical block (see Figure
9-1 on page 170). The LM3S8933 microcontroller contains seven ports and thus seven of these
physical GPIO blocks.
Programmable control for GPIO interrupts
–
–
–
5-V-tolerant input/outputs
Bit masking in both read and write operations through address lines
Pins configured as digital inputs are Schmitt-triggered.
Programmable control for GPIO pad configuration:
–
–
–
–
–
Interrupt generation masking
Edge-triggered on rising, falling, or both
Level-sensitive on High or Low values
Weak pull-up or pull-down resistors
2-mA, 4-mA, and 8-mA pad drive for digital communication; up to four pads can be configured
with an 18-mA pad drive for high-current applications
Slew rate control for the 8-mA drive
Open drain enables
Digital input enables
All GPIO pins are tri-stated by default (GPIOAFSEL=0, GPIODEN=0, GPIOPDR=0,
and GPIOPUR=0), with the exception of the five JTAG/SWD pins (PB7 and PC[3:0]).
The JTAG/SWD pins default to their JTAG/SWD functionality (GPIOAFSEL=1,
GPIODEN=1 and GPIOPUR=1). A Power-On-Reset (POR) or asserting RST puts both
groups of pins back to their default state.
Preliminary
LM3S8933 Microcontroller
169