MX29LV320MB Macronix International, MX29LV320MB Datasheet - Page 16

no-image

MX29LV320MB

Manufacturer Part Number
MX29LV320MB
Description
32M-BIT [4M x 8/2M x 16] SINGLE VOLTAGE 3V ONLY FLASH MEMORY
Manufacturer
Macronix International
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
MX29LV320MBTC-70R
Manufacturer:
MX
Quantity:
20 000
Part Number:
MX29LV320MBTI-90
Manufacturer:
VISHAY
Quantity:
1 528
system protection of the Secured Silicon Sector without
raising any device pin to a high voltage. Note that method
is only applicable to the Secured Silicon Sector.
Write the three-cycle Enter Secured Silicon Sector Re-
gion command sequence, and then alternate method of
sector protection described in the :Sector Group Protec-
tion and Unprotect" section.
Once the Secured Silicon Sector is programmed, locked
and verified, the system must write the Exit Secured
Silicon Sector Region command sequence to return to
reading and writing the remainder of the array.
LOW VCC WRITE INHIBIT
When VCC is less than VLKO the device does not ac-
cept any write cycles. This protects data during VCC
power-up and power-down. The command register and all
internal program/erase circuits are disabled, and the de-
vice resets. Subsequent writes are ignored until VCC is
greater than VLKO. The system must provide the proper
signals to the control pins to prevent unintentional write
when VCC is greater than VLKO.
WRITE PULSE "GLITCH" PROTECTION
Noise pulses of less than 5ns (typical) on CE# or WE#
will not initiate a write cycle.
LOGICAL INHIBIT
Writing is inhibited by holding any one of OE# = VIL, CE#
= VIH or WE# = VIH. To initiate a write cycle CE# and
WE# must be a logical zero while OE# is a logical one.
POWER-UP SEQUENCE
The MX29LV320MT/B powers up in the Read only mode.
In addition, the memory contents may only be altered
after successful completion of the predefined command
sequences.
P/N:PM1129
16
POWER-UP WRITE INHIBIT
If WE#=CE#=VIL and OE#=VIH during power up, the
device does not accept commands on the rising edge of
WE#. The internal state machine is automatically reset
to the read mode on power-up.
POWER SUPPLY DE COUPLING
In order to reduce power switching effect, each device
should have a 0.1uF ceramic capacitor connected be-
tween its VCC and GND.
MX29LV320MT/B
REV. 1.1 , JUL. 14, 2005
www.DataSheet4U.com

Related parts for MX29LV320MB