74HC175DB,112 NXP Semiconductors, 74HC175DB,112 Datasheet - Page 16

• Manufacturer Part Number: 74HC175DB,112
• Description: IC QUAD D F-F POS-EDGE 16-SSOP
• Manufacturer: NXP Semiconductors
• Series: 74HCr
• Type: D-Type Busr

Specifications of 74HC175DB,112

• Output Type: Differential
• Package / Case: 16-SSOP
• Function: Master Reset
• Number Of Elements: 1
• Number Of Bits Per Element: 4
• Frequency - Clock: 89MHz
• Delay Time - Propagation: 16ns
• Trigger Type: Positive Edge
• Voltage - Supply: 2 V ~ 6 V
• Operating Temperature: -40°C ~ 125°C
• Mounting Type: Surface Mount
• Number Of Circuits: 1
• Logic Family: HC
• Logic Type: D-Type Edge Triggered Flip-Flop
• Polarity: Inverting/Non-Inverting
• Input Type: Single-Ended
• Propagation Delay Time: 17 ns at 5 V
• High Level Output Current: - 5.2 mA
• Low Level Output Current: 5.2 mA
• Supply Voltage (max): 6 V
• Maximum Operating Temperature: + 125 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 40 C
• Supply Voltage (min): 2 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Current - Output High, Low: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 568-2631-5; 935187390112

Philips Semiconductors
HCMOS family characteristics
FAMILY SPECIFICATIONS
AC CHARACTERISTICS
The “AC CHARACTERISTICS” table lists the guaranteed
limits when a device is tested under the conditions given in
the AC Test Circuits and Waveforms section.
TEST CIRCUITS
Good high-frequency wiring practices should be used in
test circuits. Capacitor leads should be as short as
possible to minimize ripples on the output waveform
transitions and undershoot. Generous ground metal
(preferably a ground-plane) should be used for the same
reasons. A V
decoupling capacitor should be provided
CC
at the test socket, also with short leads. Input signals
should have rise and fall times of 6 ns, a signal swing of
0 V to V
for 74HC and 0 V to 3 V for 74HCT; a 1.0 MHz
CC
square wave is recommended for most propagation delay
tests. The repetition rate must be increased for testing
f
. Two pulse generators are usually required for testing
max
such parameters as set-up time, hold time and removal
time. f
is also tested with 6 ns input rise and fall times,
max
with a 50% duty factor, but for typical f
as high as
max
60 MHz, there are no constraints on rise and fall times.
March 1988
16