mc68hc908jl16 Freescale Semiconductor, Inc, mc68hc908jl16 Datasheet - Page 54

• Manufacturer Part Number: mc68hc908jl16
• Description: M68hc08 Microcontrollers
• Manufacturer: Freescale Semiconductor, Inc

System Integration Module (SIM)
If more than one interrupt is pending at the end of an instruction execution, the highest priority interrupt is
serviced first.
pending upon exit from the original interrupt service routine, the pending interrupt is serviced before the
LDA instruction is executed.
The LDA opcode is prefetched by both the INT1 and INT2 RTI instructions. However, in the case of the
INT1 RTI prefetch, this is a redundant operation.
4.5.1.2 SWI Instruction
The SWI instruction is a non-maskable instruction that causes an interrupt regardless of the state of the
interrupt mask (I bit) in the condition code register.
4.5.2 Interrupt Status Registers
The flags in the interrupt status registers identify maskable interrupt sources.
interrupt sources and the interrupt status register flags that they set. The interrupt status registers can be
useful for debugging.
54
Figure 4-11
To maintain compatibility with the M6805 Family, the H register is not
pushed on the stack during interrupt entry. If the interrupt service routine
modifies the H register or uses the indexed addressing mode, software
should save the H register and then restore it prior to exiting the routine.
A software interrupt pushes PC onto the stack. A software interrupt does
not push PC – 1, as a hardware interrupt does.
INT1
INT2
demonstrates what happens when two interrupts are pending. If an interrupt is
Figure 4-11
CLI
LDA
PSHH
PULH
RTI
PSHH
PULH
RTI
MC68HC908JL16 Data Sheet, Rev. 1.1
#$FF
.
Interrupt Recognition Example
NOTE
NOTE
INT1 INTERRUPT SERVICE ROUTINE
INT2 INTERRUPT SERVICE ROUTINE
BACKGROUND ROUTINE
Table 4-3
Freescale Semiconductor
summarizes the