adau1461 Analog Devices, Inc., adau1461 Datasheet - Page 75

• Manufacturer Part Number: adau1461
• Description: Sigmadsp Stereo, Low Power, 96 Khz, 24-bit Audio Codec With Integrated Pll Adau1461
• Manufacturer: Analog Devices, Inc.

R42: Jack Detect Pin Control, 16,433 (0x4031)
With IOVDD set to 3.3 V, the low and high drive strengths of the JACKDET/MICIN pin are approximately 2.0 mA and 4.0 mA, respectively.
The optional pull-up/pull-down resistors are nominally 250 kΩ. When enabled, these pull-up/pull-down resistors set the input signals to
a defined state when the signal source becomes three-state.
Bit 7
Table 74. Jack Detect Pin Control Register
Bits
5
[3:2]
R67: Dejitter Control, 16,438 (0x4036)
The dejitter control register allows the size of the dejitter window to be set, and also allows all dejitter circuits in the device to be activated or
bypassed. Dejitter circuits protect against duplicate samples or skipped samples due to jitter from the serial ports in slave mode. Disabling
and reenabling certain subsystems in the device—that is, the ADCs, serial ports, SigmaDSP core, and DACs—during operation can cause
the associated dejitter circuits to fail. As a result, audio data fails to be output to the next subsystem in the device.
When the serial ports are in master mode, the dejitter circuit can be bypassed by setting the dejitter window to 0. When the serial ports
are in slave mode, the dejitter circuit can be reinitialized prior to outputting audio from the device, guaranteeing that audio is output to
the next subsystem in the device. Any time that audio must pass through the ADCs, serial port, sound engine/DSP core, or DACs, the
dejitter circuit can be bypassed and reset by setting the dejitter window size to 0. In this way, the dejitter circuit can be immediately
reactivated, without a wait period, by setting the dejitter window size to the default value of 3.
Bit 7
Table 75. Dejitter Control Register
Bits
[7:0]
Bit Name
JDSTR
JDP[1:0]
Bit Name
DEJIT[7:0]
Reserved
Bit 6
Bit 6
JACKDET/MICIN pin drive strength.
Description
0 = low (default).
1 = high.
JACKDET/MICIN pad pull-up/pull-down configuration.
Setting
00
01
10
11
Description
Dejitter window size.
Window Size
00000000
…
00000011
…
00000101
Bit 5
JDSTR
Bit 5
Bit 4
Reserved
Bit 4
Configuration
Pull-up
Reserved
None (default)
Pull-down
Core Clock Cycles
0
…
3 (default)
…
5
Rev. 0 | Page 75 of 88
DEJIT[7:0]
Bit 3
Bit 3
JDP[1:0]
Bit 2
Bit 2
Bit 1
Bit 1
Reserved
ADAU1461
Bit 0
Bit 0