lan83c175 Standard Microsystems Corp., lan83c175 Datasheet - Page 41
![no-image](/images/no-image-200.jpg)
lan83c175
Manufacturer Part Number
lan83c175
Description
Ethernet Cardbus Integrated Controller With Modem Support Corporation
Manufacturer
Standard Microsystems Corp.
Datasheet
1.LAN83C175.pdf
(92 pages)
- Current page: 41 of 92
- Download datasheet (291Kb)
7 - TRANSMIT DMA PRIORITY: When this bit
is set, the transmit DMA
receive DMA for access to the CardBus bus.
Preemption occurs when the CardBus latency
timer expires.
6 - RECEIVE DMA PRIORITY: When this bit
is set, the receive DMA
transmit DMA for access to the CardBus bus.
Preemption occurs when the CardBus latency
timer expires.
5 - BIG ENDIAN: This bit controls the order of
the bytes on the data bus when the
LAN83C175 is used in a big endian machine.
When this bit is set to 1, the LAN83C175
performs byte swapping on the descriptor and
fragment list entries to compensate for byte
swapping by the CardBus bridge.
4 - ONECOPY: When this bit is set to 1, the
LAN83C175 will give the host only one copy
of each receive frame.
NEXTFRAME to be set automatically at the
end of each frame.
modified while the receive DMA is not idle.
3 - POWER DOWN: Setting this bit puts the
LAN83C175 into a low power
When this bit is cleared (I/O writes to this
register are still enabled in sleep mode) the
LAN83C175 will resume in the state it was in
[1]
0
0
1
1
[0]
0
1
0
1
This bit should not be
may preempt the
may preempt the
This bit causes
THRESHOLD
32 Bytes (1/4
64 Bytes (1/2
96 Bytes (3/4
sleep mode.
128 Bytes
LEVEL
(Full)
Full)
Full)
Full)
41
prior to power down. This bit may only be set
when the chip is idle.
2 - SOFTWARE INTERRUPT: When this bit is set
to a 1, the LAN83C175 interrupt pin nINTA will
become active (driven low).
1 - INTERRUPT ENABLE: Setting this bit enables
the LAN83C175 interrupt line. When one of the
interrupt status bits and its corresponding mask
bit are both set, the LAN83C175 will drive the
nINTA pin low.
interrupts (except software interrupt).
0 - SOFT RESET: Setting this bit to a 1 resets the
LAN83C175 to its initialization state. All state
machines and pointers to the internal rams will
be reset.
EEPROM control) and non-volatile control register
will NOT be reset and EEPROM recall will not
take place after a soft reset.
return to its reset value after the
complete, regardless of the data written.
10 - NON-VOLATILE CONTROL
Power Up Reset Value: 000000
31 through 15: Unused
14
FETPWRPHY output signal that is used to control
a powerdown signal to the physical layer. Upon
reset, it will be zero, and will then reflect the value
loaded into it during EEPROM recall.
13 - MULTI_FUNC:
configuration on bit 23 when the hdr type and
latency timer are read.
12 - STSCHG_EN: This bit must be high to allow
the function event register for the modem to be
driven out onto the cardbus.
-
FETPWRPHY:
The configuration registers (except
Clearing this bit
This bit is read during
This
bit
This register will
controls
operation is
masks all
the
Related parts for lan83c175
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
![USB2503-HZH](/images/no-image3.png)
Part Number:
Description:
Interface, Integrated USB2.0 Compatible 3-Port Hub
Manufacturer:
Standard Microsystems Corp.
Datasheet:
![lan91c100fd](/images/no-image3.png)
Part Number:
Description:
Lan91c100fd Rev. B Feast Fast Ethernet Controller With Full Duplex Capability
Manufacturer:
Standard Microsystems Corp.
Datasheet:
![lan91c100](/images/no-image3.png)
Part Number:
Description:
Feast ? Ast Ethernet Controller
Manufacturer:
Standard Microsystems Corp.
Datasheet:
![com20022i](/images/no-image3.png)
Part Number:
Description:
Com20022i 10 Mbps Arcnet Ansi 878.1 Controller With 2k X 8 On-chip Ram
Manufacturer:
Standard Microsystems Corp.
![lpc47n207-jv](/images/no-image3.png)
Part Number:
Description:
Lpc47n207 Lpc Super I/o Irda Hot Docking Chip With Uart Data Brief
Manufacturer:
Standard Microsystems Corp.
Datasheet:
![lpc47s457-ns](/images/no-image3.png)
Part Number:
Description:
Advanced I/o With X-bus Interface
Manufacturer:
Standard Microsystems Corp.
Datasheet:
![fdc37m707](/images/no-image3.png)
Part Number:
Description:
Fdc37m707 Enhanced Super I/o Controller With Wake-up Features
Manufacturer:
Standard Microsystems Corp.
Datasheet:
![com81c17](/images/no-image3.png)
Part Number:
Description:
Twenty Pin Uart Tpuart Corporation
Manufacturer:
Standard Microsystems Corp.
Datasheet:
![MSD7262](/images/no-image3.png)
Part Number:
Description:
Enhanced Small Device Interface Controller
Manufacturer:
Standard Microsystems Corp.
![EMC2301](/images/no-image3.png)
Part Number:
Description:
Rpm-based Pwm Fan Controller
Manufacturer:
Standard Microsystems Corp.
Datasheet:
![EMC2302](/images/no-image3.png)
Part Number:
Description:
Rpm-based Pwm Fan Controller
Manufacturer:
Standard Microsystems Corp.
Datasheet:
![EMC1001](/images/no-image3.png)
Part Number:
Description:
Emc1001 1.5?c Smbus Temperature Sensor In Miniature Sot-23
Manufacturer:
Standard Microsystems Corp.
Datasheet:
![EMC1043](/images/no-image3.png)
Part Number:
Description:
1 Degree C Triple Temperature Sensor With Beta Compensation And Hotter Of Two Zones
Manufacturer:
Standard Microsystems Corp.
Datasheet:
![EMC1046](/images/no-image3.png)
Part Number:
Description:
1 Degree C Multiple Temperature Sensor With Beta Compensation And Hottest Of Thermal Zones
Manufacturer:
Standard Microsystems Corp.
Datasheet:
![EMC1053](/images/no-image3.png)
Part Number:
Description:
1 Degree C Triple Temperature Sensor With Resistance Error Correction & Hotter Of Two Zones
Manufacturer:
Standard Microsystems Corp.
Datasheet: