lan9116 Standard Microsystems Corp., lan9116 Datasheet - Page 83
![no-image](/images/no-image-200.jpg)
lan9116
Manufacturer Part Number
lan9116
Description
Lan9116 Highly Efficient Single-chip 10/100 Non-pci Ethernet Controller
Manufacturer
Standard Microsystems Corp.
Datasheet
1.LAN9116.pdf
(132 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
lan9116-MT
Manufacturer:
XCEIVE
Quantity:
3 400
Company:
Part Number:
lan9116-MT
Manufacturer:
Standard
Quantity:
2 245
Company:
Part Number:
lan9116-MT
Manufacturer:
Microchip Technology
Quantity:
10 000
Part Number:
lan9116-MT
Manufacturer:
SMSC
Quantity:
20 000
Highly Efficient Single-Chip 10/100 Non-PCI Ethernet Controller
Datasheet
SMSC LAN9116
BITS
5-4
3
2
1
0
DESCRIPTION
WAKE-UP Status (WUPS) – This field indicates the cause of a wake-up
event detection as follows
00b -- No wake-up event detected
01b -- Energy detected
10b -- Wake-up frame or magic packet detected
11b -- Indicates multiple events occurred
WUPS bits are cleared by writing a ‘1’ to the appropriate bit. The device must
return to the D0 state (READY bit set) before these bits can be cleared.
Note:
PME indication (PME_IND). The PME signal can be configured as a pulsed
output or a static signal, which is asserted upon detection of a wake-up
event.
When set, the PME signal will pulse active for 50mS upon detection of a
wake-up event.
When clear, the PME signal is driven continously upon detection of a wake-
up event.
The PME signal can be deactivated by clearing the WUPS bits, or by
clearing the appropriate enable (refer to
Managment Event Indicators," on page
PME Polarity (PME_POL). This bit controls the polarity of the PME signal.
When set, the PME output is an active high signal. When reset, it is active
low. When PME is configured as an open-drain output this field is ignored,
and the output is always active low.
PME Enable (PME_EN). When set, this bit enables the external PME signal.
This bit does not affect the PME interrupt (PME_INT).
Device Ready (READY). When set, this bit indicates that LAN9116 is ready
to be accessed. This register can be read when LAN9116 is in any power
management mode. Upon waking from any power management mode,
including power-up, the host processor can interrogate this field as an
indication when LAN9116 has stabilized and is fully alive. Reads and writes
of any other address are invalid until this bit is set.
Note:
In order to clear this bit, it is required that all event sources be
cleared as well. The event sources are decribed in
and PME_INT Signal Generationon page
With the exception of HW_CFG and PMT_CTRL, read access to
any internal resources is forbidden while the READY bit is cleared.
DATASHEET
40).
Section 3.10.2.3, "Power
83
40.
Figure 3.11 PME
TYPE
NASR
R/WC
R/W
R/W
R/W
RO
Revision 1.5 (07-11-08)
DEFAULT
00
0b
0b
0b
-