ata6603 ATMEL Corporation, ata6603 Datasheet - Page 309

• Manufacturer Part Number: ata6603
• Description: Microcontroller With Lin Transceiver, 5v Regulator And Watchdog
• Manufacturer: ATMEL Corporation

4.24.7.7
4.24.7.8
4.24.7.9
4.24.7.10
4921D–AUTO–08/07
Reading the EEPROM
Programming the Fuse Low Bits
Programming the Fuse High Bits
Programming the Extended Fuse Bits
The algorithm for reading the EEPROM memory is as follows (refer to
on page 305
The algorithm for programming the Fuse Low bits is as follows (refer to
on page 305
The algorithm for programming the Fuse High bits is as follows (refer to
Flash” on page 305
The algorithm for programming the Extended Fuse bits is as follows (refer to
Flash” on page 305
1. A: Load Command “0000 0011”.
2. G: Load Address High Byte (0x00 - 0xFF).
3. B: Load Address Low Byte (0x00 - 0xFF).
4. Set OE to “0”, and BS1 to “0”. The EEPROM Data byte can now be read at DATA.
5. Set OE to “1”.
1. A: Load Command “0100 0000”.
2. C: Load Data Low Byte. Bit n = “0” programs and bit n = “1” erases the Fuse bit.
3. Give WR a negative pulse and wait for RDY/BSY to go high.
1. A: Load Command “0100 0000”.
2. C: Load Data Low Byte. Bit n = “0” programs and bit n = “1” erases the Fuse bit.
3. Set BS1 to “1” and BS2 to “0”. This selects high data byte.
4. Give WR a negative pulse and wait for RDY/BSY to go high.
5. Set BS1 to “0”. This selects low data byte.
1. 1. A: Load Command “0100 0000”.
2. 2. C: Load Data Low Byte. Bit n = “0” programs and bit n = “1” erases the Fuse bit.
3. 3. Set BS1 to “0” and BS2 to “1”. This selects extended data byte.
4. 4. Give WR a negative pulse and wait for RDY/BSY to go high.
5. 5. Set BS2 to “0”. This selects low data byte.
for details on Command and Address loading):
for details on Command and Data loading):
for details on Command and Data loading):
for details on Command and Data loading):
ATA6602/ATA6603
“Programming the Flash”
“Programming the Flash”
“Programming the
“Programming the
309