pxb4340e Infineon Technologies Corporation, pxb4340e Datasheet - Page 132
pxb4340e
Manufacturer Part Number
pxb4340e
Description
Atm Oam Processor Aop
Manufacturer
Infineon Technologies Corporation
Datasheet
1.PXB4340E.pdf
(185 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
pxb4340eV1.1
Manufacturer:
TI
Quantity:
12 388
Company:
Part Number:
pxb4340eV1.1
Manufacturer:
INFINEON
Quantity:
885
Part Number:
pxb4340eV1.1
Manufacturer:
INFINEON/英飞凌
Quantity:
20 000
- Current page: 132 of 185
- Download datasheet (2Mb)
The transmission of a LB cell is usually initiated by the system controller. The parameters
• LCI
• segment or end-to-end or intra-domain LB
• the Location identifier in case of intra-domain LB
must be given by the system controller. Note that in case of a segment or end-to-end LB the
location and source ID are set to all ones. The microprocessor assembles the LB cell and
transmits it via the AOP. A timer is started for time-out supervision.
Prior to transmission the LB State bit is set for this connection. This bit causes the returning LB
cell to be copied to the receive buffer. If it is not set the backward LB cell is discarded without
notice. By comparing the correlation tag the peripheral controller makes sure that the cell was
the one sent out before.
The request to do performance monitoring over a given VPC or VCC connection or segment is
initiated by the system controller and sent to the originating point microprocessor. The
parameters
• LCI or LCI2 (for F4 PM)
• Block size (128, 256, 512, 1024)
must be given. Similar to the LB procedure the microprocessor generates an appropriate
activation cell for either segment or end-to-end, depending on the given configuration. After
reception of the confirmation cell (
well as a data collection processor in the opposite direction. There are two restrictions to be
checked:
• there are at most 128 processors for FM generation or analysis and 128 processors for data
• not more than 2 processors can be invoked for one user cell, one for F4 and one for F5
An activation/ deactivation cell may be received at any time at the receive buffer of the AOP. In
such a case the peripheral controller looks for a free PM processor and assigns it to the
connection. The PM processor is initialized in analyzing mode. Then a confirmation cell is sent
back to the originating port. The PM endpoint is now ready for reception of the first FM cell.
Data Sheet
collection
(
).
4-132
) the FM generation processor is assigned as
04.2000
Related parts for pxb4340e
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
Antenna Switch Silicon Pin Diode
Manufacturer:
Infineon Technologies Corporation
Datasheet:
Part Number:
Description:
Silicon Switching Diodes
Manufacturer:
Infineon Technologies Corporation
Datasheet:
Part Number:
Description:
Single Igbt Driver Ic
Manufacturer:
Infineon Technologies Corporation
Datasheet:
Part Number:
Description:
Igbt Modules
Manufacturer:
Infineon Technologies Corporation
Datasheet:
Part Number:
Description:
Igbt Modules
Manufacturer:
Infineon Technologies Corporation
Datasheet:
Part Number:
Description:
Igbt Modules
Manufacturer:
Infineon Technologies Corporation
Datasheet:
Part Number:
Description:
5 Volt Standard Regulator
Manufacturer:
Infineon Technologies Corporation
Datasheet:
Part Number:
Description:
Active Biased Transistor
Manufacturer:
Infineon Technologies Corporation
Datasheet:
Part Number:
Description:
N-channel Small Signal Mosfet 20v?800v
Manufacturer:
Infineon Technologies Corporation
Datasheet:
Part Number:
Description:
Sipmos Small-signal Transistor
Manufacturer:
Infineon Technologies Corporation
Datasheet:
Part Number:
Description:
Complementary Mosfets 60v Small-signal-transistor
Manufacturer:
Infineon Technologies Corporation
Datasheet:
Part Number:
Description:
Complementary Mosfets 60v
Manufacturer:
Infineon Technologies Corporation
Datasheet:
Part Number:
Description:
P-channel Mosfets Power-transistor
Manufacturer:
Infineon Technologies Corporation
Datasheet:
Part Number:
Description:
N-channel Mosfet 20v?300v Power Transistor Power Mosfet
Manufacturer:
Infineon Technologies Corporation
Datasheet:
Part Number:
Description:
Power Mosfets
Manufacturer:
Infineon Technologies Corporation
Datasheet: