w25q80bv Winbond Electronics Corp America, w25q80bv Datasheet - Page 52

• Manufacturer Part Number: w25q80bv
• Description: 8m-bit Serial Flash Memory With Dual And Quad Spi
• Manufacturer: Winbond Electronics Corp America

10.2.33 Read Manufacturer / Device ID Quad I/O (94h)
The Read Manufacturer / Device ID Quad I/O instruction is an alternative to the Read Manufacturer /
Device ID instruction that provides both the JEDEC assigned manufacturer ID and the specific device ID
at 4x speed.
The Read Manufacturer / Device ID Quad I/O instruction is similar to the Fast Read Quad I/O instruction.
The instruction is initiated by driving the /CS pin low and shifting the instruction code “94h” followed by a
four clock dummy cycles and then a 24-bit address (A23-A0) of 000000h, but with the capability to input
the Address bits four bits per clock. After which, the Manufacturer ID for Winbond (EFh) and the Device
ID are shifted out four bits per clock on the falling edge of CLK with most significant bit (MSB) first as
shown in figure 31. The Device ID values for the W25Q80BV is listed in Manufacturer and Device
Identification table. If the 24-bit address is initially set to 000001h the Device ID will be read first and then
followed by the Manufacturer ID. The Manufacturer and Device IDs can be read continuously, alternating
from one to the other. The instruction is completed by driving /CS high.
Note:
The “Continuous Read Mode” bits M7-0 must be set to Fxh to be compatible with Fast Read Quad I/O instruction.
Figure 31. Read Manufacturer / Device ID Quad I/O Diagram
- 52 -
W25Q80BV