stm8af6166t STMicroelectronics, stm8af6166t Datasheet - Page 53

• Manufacturer Part Number: stm8af6166t
• Description: Automotive 8-bit Mcu, With Up To 128 Kbytes Flash, Eeprom, 10-bit Adc, Timers, Lin, Can, Usart, Spi, I2c, 3 V To 5.5 V
• Manufacturer: STMicroelectronics

STM8AF61xx, STM8AF51xx
Table 15.
1. All power (V
2. I
3. Negative injection disturbs the analog performance of the device. See note in
4. When several inputs are submitted to a current injection, the maximum
Table 16.
I
ΣI
INJ(PIN)
external supply.
cannot be respected, the injection current must be limited externally to the I
injection is induced by V
there is no positive injection current, and the corresponding V
characteristics on page
positive and negative injected currents (instantaneous values). These results are based on
characterization with
INJ(PIN)
Symbol
INJ(PIN)
Symbol
I
I
VDD
VSS
I
T
IO
STG
T
(2)(3)
J
must never be exceeded. This is implicitly insured if V
(2)
Current characteristics
Thermal characteristics
DD
, V
Total current into V
Total current out of V
Output current sunk by any I/O and control pin
Output current source by any I/Os and control pin
Injected current on NRST pin
Injected current on OSC_IN pin
Injected current on any other pin
Total injected current (sum of all I/O and control pins)
DDIO
Σ
, V
I
INJ(PIN)
71.
IN
DDA
>V
DD
) and ground (V
Maximum junction temperature
maximum current injection on four I/O port pins of the device.
while a negative injection is induced by V
Storage temperature range
DD
SS
power lines (source)
Ratings
ground lines (sink)
SS
Ratings
, V
SSIO
(4)
, V
SSA
) pins must always be connected to the
IN
IN
maximum must always be respected
(1)
maximum is respected. If V
(1)
Σ
I
IN
INJ(PIN)
<V
INJ(PIN)
(4)
SS
Electrical characteristics
Section 11.3.8: 10-bit ADC
. For true open-drain pads,
-65 to +150
is the absolute sum of the
value. A positive
Value
150
Max.
± 20
- 20
± 4
± 4
± 4
60
60
20
IN
maximum
Unit
Unit
°C
mA
53/84