stm8af6199 STMicroelectronics, stm8af6199 Datasheet - Page 85

• Manufacturer Part Number: stm8af6199
• Description: Automotive 8-bit Mcu, With Up To 128 Kbytes Flash, Eeprom, 10-bit Adc, Timers, Lin, Can, Usart, Spi, I 2c, 3 V To 5.5 V
• Manufacturer: STMicroelectronics

STM8AF61xx, STM8AF51xx
11.3.11
Figure 42. Typical application with ADC
EMC characteristics
Susceptibility tests are performed on a sample basis during product characterization.
Functional EMS (electromagnetic susceptibility)
While executing a simple application (toggling 2 LEDs through I/O ports), the product is
stressed by two electromagnetic events until a failure occurs (indicated by the LEDs).
●
●
A device reset allows normal operations to be resumed. The test results are given in the
table below based on the EMS levels and classes defined in application note AN1709.
Designing hardened software to avoid noise problems
EMC characterization and optimization are performed at component level with a typical
application environment and simplified MCU software. It should be noted that good EMC
performance is highly dependent on the user application and the software in particular.
Therefore it is recommended that the user applies EMC software optimization and
prequalification tests in relation with the EMC level requested for his application.
Software recommendations
The software flowchart must include the management of runaway conditions such as:
●
●
●
Prequalification trials
Most of the common failures (unexpected reset and program counter corruption) can be
recovered by applying a low state on the NRST pin or the oscillator pins for 1 second.
To complete these trials, ESD stress can be applied directly on the device, over the range of
specification values. When unexpected behavior is detected, the software can be hardened
to prevent unrecoverable errors occurring (see application note AN1015).
ESD : Electrostatic discharge (positive and negative) is applied on all pins of the device
until a functional disturbance occurs. This test conforms with the IEC 1000-4-2
standard.
FTB : A burst of fast transient voltage (positive and negative) is applied to V
through a 100 pF capacitor, until a functional disturbance occurs. This test conforms
with the IEC 1000-4-4 standard.
Corrupted program counter
Unexpected reset
Critical data corruption (control registers...)
V
AIN
R
AIN
C
AIN
AINx
V
DD
V
0.6V
V
0.6V
T
T
I
¬±1¬
L
conversion
10-bit A/D
Electrical characteristics
STM8A
C
ADC
DD
and V
85/100
SS