sc60021rm Staco Energy Products Co., sc60021rm Datasheet - Page 21

• Manufacturer Part Number: sc60021rm
• Description: Parallel Redundancy/capacity On-line Ups
• Manufacturer: Staco Energy Products Co.

3.5. Operation Test and Installation Instruction
Start Up in Normal Mode
3.5.1.1
3.5.1.2
3.5.1.3
3.5.1.4
3.5.1.5
3.5.1.6
installation make sure the unit is properly grounded.
UPS.
according to the instructions in section 3.4. Apply power to the UPS and
switch on the breakers of the UPS Inputs. The UPS starts and Green
LEDs
normal and the LCD display with parallel function will display as shown
in drawing A to drawing B.
automatically. If there are no abnormal messages then the self-test was
successful and the charger starts to charge the batteries.
sounds twice and the LCD display changes from drawing B to drawing
C.
Open the terminal block cover on the rear panel (refer to 0). Before
Make sure Utility breaker, UPS’ Utility breaker is On “Off” position.
Make sure the Utility voltage matches the input voltage rating of the
Connect the utility and the bypass inputs and load to the terminal blocks
The UPS is now in Bypass Mode and it will proceed to self-test
Press the UPS On Switch
A.
B.
C
&
light up to show the Utility and Bypass Inputs are
20
for approx. 3 seconds, then the alarm