sc60021rm Staco Energy Products Co., sc60021rm Datasheet - Page 23

• Manufacturer Part Number: sc60021rm
• Description: Parallel Redundancy/capacity On-line Ups
• Manufacturer: Staco Energy Products Co.

3.5.1.9
Start-up in Battery Mode (Cold Start)
3.5.1.10 Make sure the UPS has a fully charged battery pack. At least 1 set
3.5.1.11 Push the UPS On Switch
3.5.1.12 Within 15 seconds, press the UPS On Switch
Start-up operation of the UPS is completely now. Make sure the UPS
is plugged onto the wall receptacle for charging at least 8 hours and the
batteries of the UPS are fully charged.
(20pcs) of 12V/7AH or 12V/5AH batteries.
the UPS. The alarm sounds twice. The LCD display will illustrate from
drawing A to drawing G, and stay on for approx. 15 seconds.
seconds, until the LCD display changes from drawing G to drawing H,
then the UPS will be in self-test Mode. The UPS will start the inverter to
energize the output in approx. one minute, and the LCD display will
show as drawing I. Failure to press the UPS On Switch within 15
seconds, will cause a failure to start and you will then have to repeat
steps 3.5.1.10 to 3.5.1.123 once again.
G
H
I
* Display shows “Off”, which means the UPS pre-start is successful.
* Disply shows Utility input is “0” and Utility Abnormal.
22
once for approx. 5 seconds to initialize
again for about 3