cop888ek National Semiconductor Corporation, cop888ek Datasheet - Page 13

• Manufacturer Part Number: cop888ek
• Description: 8-bit Cmos Rom Based Microcontrollers With 8k Memory, Comparator, And Single-slope A/d Capability
• Manufacturer: National Semiconductor Corporation

Typical Performance Characteristics
Pin Descriptions
V
pins must be connected.
CKI is the clock input. This can come from an R/C generated
oscillator, or a crystal oscillator (in conjunction with CKO).
See Oscillator Description section.
RESET is the master reset input. See Reset Description sec-
tion.
The device contains three bidirectional 8-bit I/O ports (C, G
and L), where each individual bit may be independently con-
figured as an input (Schmitt Trigger inputs on ports L and G),
output or TRI-STATE under program control. Three data
memory address locations are allocated for each of these
I/O ports. Each I/O port has two associated 8-bit memory
mapped registers, the CONFIGURATION register and the
output DATA register. A memory mapped address is also re-
served for the input pins of each I/O port. (See the memory
map for the various addresses associated with the I/O ports.)
Figure 4 shows the I/O port configurations. The DATA and
CONFIGURATION registers allow for each port bit to be in-
dividually configured under software control as shown below:
PORT L is an 8-bit I/O port. All L-pins have Schmitt triggers
on the inputs.
The Port L supports Multi-Input Wake Up on all eight pins. L4
and L5 are used for the timer input functions T2A and T2B.
L6 and L7 are used for the timer input functions T3A and
T3B.
CC
CONFIGURA-
and GND are the power supply pins. All V
Register
TION
0
0
1
1
Register
DATA
0
1
0
1
Hi-Z Input
(TRI-STATE Output)
Input with Weak Pull-Up
Push-Pull Zero Output
Push-Pull One Output
Port Set-Up
CC
DS012094-29
and GND
(−55˚C
13
The Port L has the following alternate features:
Port G is an 8-bit port with 5 I/O pins (G0, G2–G5), an input
pin (G6), and a dedicated output pin (G7). Pins G0 and
G2–G6 all have Schmitt Triggers on their inputs. Pin G1
serves as the dedicated WDOUT WATCHDOG output, while
pin G7 is either input or output depending on the oscillator
mask option selected. With the crystal oscillator option se-
lected, G7 serves as the dedicated output pin for the CKO
clock output. With the single-pin R/C oscillator mask option
selected, G7 serves as a general purpose input pin but is
also used to bring the device out of HALT mode with a low to
high transition on G7. There are two registers associated
with the G Port, a data register and a configuration register.
Therefore, each of the 5 I/O bits (G0, G2–G5) can be indi-
vidually configured under software control.
Since G6 is an input only pin and G7 is the dedicated CKO
clock output pin (crystal clock option) or general purpose in-
put (R/C clock option), the associated bits in the data and
configuration registers for G6 and G7 are used for special
purpose functions as outlined on the next page. Reading the
G6 and G7 data bits will return zeros.
L7
L6
L5
L4
L3
L2
L1
L0
T
A
MIWU or T3B
MIWU or T3A
MIWU or T2B
MIWU or T2A
MIWU
MIWU
MIWU
MIWU
= +125˚C) (Continued)
DS012094-30
www.national.com