73s1209f68im Maxim Integrated Products, Inc., 73s1209f68im Datasheet - Page 76

• Manufacturer Part Number: 73s1209f68im
• Description: Self-contained Pinpad, Smart Card Reader Ic Uart To Iso7816 / Emv Bridge Ic
• Manufacturer: Maxim Integrated Products, Inc.

76
t1: The time from setting VCCSEL bits until VCCOK = 1.
tto: The time from setting VCCSEL bits until VCCTMR times out. At t1 (if RDYST = 1) or tto (if RDYST = 0),
activation starts. It is suggested to have RDYST = 0 and use the VCCTMR interrupt to let MPU know when
sequence is starting.
t2: time from start of activation (no external indication) until IO goes into reception mode (= 1).
approximately 4
t3: minimum one half of ETU period.
t4: ETU period.
Note that in Sync mode, IO as input is sampled on the rising edge of CLK. IO changes on the falling edge of CLK,
either from the card or from the 73S1209F. The RST signal to the card is directly controlled by the RSTCRD bit
(non-inverted) via the MPU and is shown as an example of a possible RST pattern.
1. Clear CLKOFF after Card is in reception mode.
2. Set RST bit.
3. Interrupt is generated when Rlength counter is MAX.
4. Read and clear Interrupt.
5. Clear RST bit.
6. Toggle TX/RXB to reset bit counter.
7. Reload RLength Counter.
TX/RXB Mode bit
Rlength Interrupt
IO reception on
RLength Count
RLenght = 1
(TX = '1')
RSTCRD
VCCOK
CLKOFF
CLKLVL
VCCSEL
Figure 20: Example of Sync Mode Operation: Generating/Reading ATR Signals
VCC
RST
CLK
RST
CLK
bits
IO
SCCLK
(or SCECLK) clock cycles.
t1
1
t1
tto
2
Figure 19: Synchronous Activation
Count MAX
t2
3
t3
6
4
5
t1. CLK wll start at least 1/2 ETU after CLKOFF is set low
when CLKLVL = 0
7
t4
Rev. 1.2
This is