hn58x2408fpiage Renesas Electronics Corporation., hn58x2408fpiage Datasheet - Page 7

• Manufacturer Part Number: hn58x2408fpiage
• Description: Memory>eeprom>serial Eeprom Two-wire Serial Interface
• Manufacturer: Renesas Electronics Corporation.

HN58X2408/HN58X2416/HN58X2432/HN58X2464FPIAG
Pin Function
Serial Clock (SCL)
The SCL pin is used to control serial input/output data timing. The SCL input is used to positive edge
clock data into EEPROM device and negative edge clock data out of each device. Maximum clock rate is
400 kHz.
Serial Input/Output Data (SDA)
The SDA pin is bidirectional for serial data transfer. The SDA pin needs to be pulled up by resistor as that
pin is open-drain driven structure. Use proper resistor value for your system by considering V
the SDA pin capacitance. Except for a start condition and a stop condition which will be discussed later,
the SDA transition needs to be completed during the SCL low period.
Data Validity (SDA data change timing waveform)
Note:
Rev.3.00, Dec.21.2004, page 7 of 19
SCL
SDA
High-to-low and low-to-high change of SDA should be done during the SCL low period.
change
Data
change
Data
OL
, I
OL
and