s5u1c17001c Epson Electronics America, Inc., s5u1c17001c Datasheet - Page 568

• Manufacturer Part Number: s5u1c17001c
• Description: Cmos 16-bit Application Specific Controller
• Manufacturer: Epson Electronics America, Inc.

11 OTHER TOOLS
11.6.4 Error/Warning Messages
The following shows the error and warning messages generated by the moto2ff:
11.6.5 Creating ROM Area Data
After a Motorola S3 format HEX file has been generated by the objcopy, convert it into ROM area data using the
moto2ff.
Open the command prompt window and execute moto2ff as shown below.
Example: C:\EPSON\gnu17\>moto2ff 8000 10000 input.sa
The command above outputs the data of 0x10000 bytes starting from address 0x8000 contained in input.sa to
input.saf. The unused addresses within the range from addresses 0x8000 to 0x17fff are filled with 0xff.
The ROM area data file for the internal ROM are generated by the above procedure.
After that convert the ROM area data file generated here into the Motorola S2 format ROM data file using sconv32.
Then perform the final verification of program operation on the actual target board using that file.
Finally, pack the verified ROM data file and the mask option data file generated by winfog into a mask data file
using winmdc and present it to Seiko Epson.
11-26
Input filename is over 128 letters.
Cannot open input file " FILENAME ".
Cannot open output file " FILENAME ".
Motorola S3 checksum error.
Cannot allocate memory.
FILENAME contains data outside of specified range
(" STARTADDR ":" SIZE ")
Invalid file format in " FILENAME " line " NUMBER ".
Warning message
Error message
Table 11.6.4.2 Warning messages
Table 11.6.4.1 Error messages
EPSON
The input file name has exceeded 128 characters.
The input file FILENAME cannot be opened.
The output file FILENAME cannot be opened.
A checksum error occurred while reading Motorola S3
format file.
Cannot allocate memory.
The input file FILENAME contains data that exceeds
the specified range ( SIZE bytes from STARTADDR ). Data
exceeded the specified range is not output.
The input file FILENAME contains an invalid format data at
line NUMBER .
(C COMPILER PACKAGE FOR S1C17 FAMILY) (Ver. 1.1)
Description
Description
S5U1C17001C MANUAL