hb28d032bp2 Renesas Electronics Corporation., hb28d032bp2 Datasheet - Page 44

• Manufacturer Part Number: hb28d032bp2
• Description: Mobile Embedded Flash With Multimediacard-tm Interface 16 Mbyte/32 Mbyte
• Manufacturer: Renesas Electronics Corporation.

HB28E016/D032BP2
Responses
All responses are sent via command line (CMD), all data starts with the MSB.
Format R1 (response command): response length 48 bit.
The contents of the status field are described in Chapter “Status”
Format R1b (response command with busy signal):
R1b is identical to R1 with an optional busy signal transmitted on the data line. The card may become busy
after receiving these commands based on its state prior to the command reception.
Format R2 (CID, CSD register): response length 136 bits.
Note: Bit 127 down to bit 1 of CID and CSD are transferred, the reserved bit [0] is replaced by the end bit.
CID register is sent as a response to commands CMD2 and CMD10.
CSD register is sent as a response to the CMD9.
Format R3 (OCR): response length 48 bits.
The OCR is sent as a response to the CMD1 to signalize the supported voltage range. These Hitachi
Mobile Embedded Flashes support the range from 2.7 V to 3.6 V. Respectively the value of all bits of the
OCR field of these Hitachi Mobile Embedded Flashes is set to 0x80FF8000. So the R3 frame contains the
value 0x3F80FF8000FF if the card is ready and 0x3F00FF8000FF if the card is busy.
44
0
start bit
0
start bit
0
start bit
0
card
0
card
0
card
bit5...bit0
command
bit5...bit0
reserved
bit5...bit0
reserved
bit127...bit1
CID or CSD register
including internal CRC
bit31...bit0
status
bit31...bit0
OCR field
bit6...bit0
CRC
bit6...bit0
reserved
1
end bit
1
end bit
1
end bit