smc256af Numonyx, smc256af Datasheet - Page 67

• Manufacturer Part Number: smc256af
• Description: 32 Mbyte, 64 Mbyte, 128 Mbyte, 256 Mbyte And 512 Mbyte 3.3 V / 5 V Supply Compactflash? Card
• Manufacturer: Numonyx

SMCxxxAF
9.17
9.18
Set Multiple mode command (C6h)
This command enables the card to perform Read and Write Multiple operations and
establishes the block count for these commands. The Sector Count register is loaded with
the number of sectors per block. Upon receipt of the command, the card sets BSY and
checks the Sector Count register.
If the Sector Count register contains a valid value and the block count is supported, the
value is loaded for all subsequent Read Multiple and Write Multiple commands and
execution is enabled. If a block count is not supported, an aborted command error is posted,
and Read Multiple and Write Multiple commands are disabled. If the Sector Count register
contains ‘0’ when the command is issued, Read and Write Multiple commands are disabled.
At power-on the default mode is Read and Write Multiple disabled, unless it is disabled by a
Set Feature command.
Table 68.
Set Sleep mode command (99h or E6h)
This command causes the CompactFlash memory card to set BSY, enter the Sleep mode,
clear BSY and generate an interrupt. Recovery from sleep mode is accomplished by simply
issuing another command. Sleep mode is also entered when internal timers expire so the
host does not need to issue this command except when it wishes to enter Sleep mode
immediately. The default value for the timer is 5 milliseconds. Note that this time base
(5 ms) is different from the ATA specification.
command byte sequence.
Table 69.
Command (7)
Command (7)
Sect Num (3)
Sect Num (3)
Sect Cnt (2)
Sect Cnt (2)
Cyl High (5)
Cyl High (5)
Cyl Low (4)
Cyl Low (4)
Feature (1)
Feature (1)
C/D/H (6)
C/D/H (6)
Bit
Bit
Set Multiple mode
Set Sleep mode
7
7
Table 68
X
6
X
6
defines the Set Multiple Mode command byte sequence.
5
5
Drive
Drive
Table 69
4
4
Sector Count
99h or E6h
C6h
X
X
X
X
X
X
X
X
X
defines the Set Sleep mode
3
3
CF-ATA command description
2
2
X
X
1
1
0
0
67/82