x25170 IC MICROSYSTEMS, x25170 Datasheet - Page 4

• Manufacturer Part Number: x25170
• Description: Spi Serial E 2 Prom With Block Lock ? Protection
• Manufacturer: IC MICROSYSTEMS

X25170
Write-Protect Enable
The Write-Protect-Enable (WPEN) bit is available for
the X25170 as a nonvolatile enable bit for the WP pin.
The Write Protect (WP) pin and the nonvolatile Write
Protect Enable (WPEN) bit in the Status Register con-
trol the programmable hardware write protect feature.
Hardware write protection is enabled when WP pin is
LOW, and the WPEN bit is “1”. Hardware write protec-
tion is disabled when either the WP pin is HIGH or the
Clock and Data Timing
Data input on the SI line is latched on the rising edge
of SCK. Data is output on the SO line by the falling
edge of SCK.
Read Sequence
When reading from the E
first pulled LOW to select the device. The 8-bit READ
instruction is transmitted to the X25170, followed by the
16-bit address of which the last 11 are used. After the
READ opcode and address are sent, the data stored in
the memory at the selected address is shifted out on the
SO line. The data stored in memory at the next address
can be read sequentially by continuing to provide clock
WPEN
X
X
0
0
1
1
HIGH
HIGH
LOW
LOW
WP
X
X
WEL
2
PROM memory array, CS is
0
1
0
1
0
1
Protected Blocks
Protected
Protected
Protected
Protected
Protected
Protected
WPEN bit is “0”. When the chip is hardware write pro-
tected, nonvolatile writes are disabled to the Status
Register, including the Block Protect bits and the
WPEN bit itself, as well as the block-protected sections
in the memory array. Only the sections of the memory
array that are not block-protected can be written.
Note: Since the WPEN bit is write protected, it cannot
be changed back to a “0”, as long as the WP pin is held
LOW.
pulses. The address is automatically incremented to the
next higher address after each byte of data is shifted
out. When the highest address is reached ($07FF), the
address counter rolls over to address $0000, allowing
the read cycle to be continued indefinitely. The read
operation is terminated by taking CS HIGH. Refer to the
read E2PROM array operation sequence illustrated in
Figure 1.
To read the status register the CS line is first pulled
LOW to select the device followed by the 8-bit RDSR
instruction. After the RDSR opcode is sent, the con-
tents of the status register are shifted out on the SO
line. The read status register sequence is illustrated in
Figure 2.
Unprotected Blocks
Protected
Protected
Protected
Writable
Writable
Writable
Characteristics subject to change without notice.
Status Register
Protected
Protected
Protected
Protected
Writable
Writable
4 of 15