masw-003103-1364 M/A-COM Technology Solutions, Inc., masw-003103-1364 Datasheet - Page 6
![no-image](/images/no-image-200.jpg)
masw-003103-1364
Manufacturer Part Number
masw-003103-1364
Description
Hmictm Silicon Diode Sp3t Switch
Manufacturer
M/A-COM Technology Solutions, Inc.
Datasheet
1.MASW-003103-1364.pdf
(8 pages)
6
ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions
is considering for development. Performance is based on target specifications, simulated results,
and/or prototype measurements. Commitment to develop is not guaranteed.
PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology
Solutions has under development. Performance is based on engineering tests. Specifications are
typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available.
Commitment to produce in volume is not guaranteed.
HMIC
50 MHz - 20 GHz
MASW-003103-1364
Handling Procedures
Attachment to a circuit board is made simple through the use of standard surface mount technology. Mounting
pads are conveniently located on the bottom surface of these devices and are removed from the active junction
locations. These devices are well suited for solder attachment onto hard and soft substrates. The use of
80Au/20Sn, or RoHS compliant solders is recommended. For applications where the average power is ≤ 1W,
conductive silver epoxy may also be used. Cure per manufacturers recommended time and temperature. Typi-
cally 1 hour at 150°C.
When soldering these devices to a hard substrate, a solder re-flow method is preferred. A vacuum tip pick-up
tool and a force of 60 to100 grams applied to the top surface of the device while placing the chip is recom-
mended. When soldering to soft substrates, such as Duroid, it is recommended to use a soft solder at the circuit
board to mounting pad interface to minimize stress due to any TCE mismatches that may exist. Position the die
so that its mounting pads are aligned with the circuit board mounting pads. Solder reflow should not be per-
formed by causing heat to flow through the top surface of the die to the back. Since the HMIC glass is transpar-
ent, the edges of the mounting pads can be visually inspected through the die after attachment is completed.
Typical re-flow profiles for Sn60/Pb40 and RoHS compliant solders is provided in
“Surface Mounting Instructions“ and can viewed on the MA-COM Technology Solutions website @
www.macomtech.com
TM
Silicon PIN Diode SP3T Switch
M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make
changes to the product(s) or information contained herein without notice.
• North America Tel: 800.366.2266 / Fax: 978.366.2266
• Europe Tel: 44.1908.574.200 / Fax: 44.1908.574.300
• Asia/Pacific Tel: 81.44.844.8296 / Fax: 81.44.844.8298
Visit www.macomtech.com for additional data sheets and product information.
Application Note M538
Rev. V6P
,