STV-5410-R01 STMICROELECTRONICS [STMicroelectronics], STV-5410-R01 Datasheet - Page 71

• Manufacturer Part Number: STV-5410-R01
• Description: Mono and Colour Digital Video CMOS Image Sensors
• Manufacturer: STMICROELECTRONICS [STMicroelectronics]

CMOS Sensor; Customer Datasheet, Rev 3.0, 28 September 2000
5
6
7
Bit
OEB pin
OEB pin
0
0
1
1
0
0
1
1
FST/LST Enable/Tri-state
QCK Enable/Tri-state
Pre clock generator divide
On/Off
Function
data_format[5]
data_format[6]
0
1
0
1
0
1
0
1
Commercial in confidence
Table 41 : FST/LST output control
Table 40 : [22], [16] - data_format
cd5410-6410f-3-0.fm
Table 42 : QCK output control
oeb_composite
oeb_composite
Default
0
0
0
0
1
1
1
0
1
1
1
The FST/LST digital outputs can be tri-stated but are
enabled as outputs by default. The enabling/disabling
of FST/LST can be retimed to a field boundary. The
state of this control bit is always available via a serial
interface read, i.e. it does not have to wait to change
state at a field boundary
The QCK output can be tri-stated independently. The
enabling/disabling of QCK can be retimed to a field
boundary. The state of this control bit is always availa-
ble via a serial interface read, i.e. it does not have to
wait to change state at a field boundary.
The CIF and QCIF video modes expect a recom-
mended set of input clock frequencies, however the
acceptable range of clock frequencies can be extended
if this bit is set. If this bit is set then the primary input
clock will be divided down by 1.5 prior to the clock gen-
erator, thus if the expected clock input is 16 MHz, we
can set this bit and accept 24 MHz and achieve the
same final frame rate.
FST/LST outputs enabled.
FST/LST outputs are tri-stated by
data_format[5]
FST/LST outputs are tri-stated by OEB pin.
FST/LST outputs are tri-stated.
QCK output enabled.
QCK output is tri-stated by op_format[6]
QCK output is tri-stated by OEB pin.
QCK output is tri-stated.
Comment
Comments
Comments
VV5410 & VV6410
71/105