Z86E30 Zilog., Z86E30 Datasheet - Page 31

• Manufacturer Part Number: Z86E30
• Description: Z8 4K OTP Microcontroller
• Manufacturer: Zilog.

Zilog
Comparator Inputs. Port 3, P31, and P32, each have a
comparator front end. The comparator reference voltage
P33 is common to both comparators. In analog mode, P31
and P32 are the positive input of the comparators and P33
is the reference voltage of the comparators.
Auto Latch. The Auto Latch puts valid CMOS levels on all
CMOS inputs (except P33-P31) that are not externally
driven. Whether this level is 0 or 1, cannot be determined.
A valid CMOS level, rather than a floating node, reduces
excessive supply current flow in the input buffer. Auto
Latches are available on Port 0, Port 2, and P30. There
are no Auto Latches on P31, P32, and P33.
Low EMI Emission. The Z86E40 can be programmed to
operate in a low EMI Emission Mode in the PCON register.
The oscillator and all I/O ports can be programmed as low
EMI emission mode independently. Use of this feature re-
sults in:
DS97Z8X0500
P30
P31
P32
P33
P34
P35
P36
P37
Pin
OUT
OUT
OUT
OUT
I/O
IN
IN
IN
IN
CTC1
T
T
OUT
IN
Table 9. Port 3 Pin Assignments
AN1-Out
An2-Out
Analog
REF
AN1
AN2
P R E L I M I N A R Y
Interrupt
IRQ3
IRQ2
IRQ0
IRQ1
The pre-drivers slew rate reduced to 10 ns typical.
Low EMI output drivers have resistance of 200 Ohms
(typical).
Low EMI Oscillator.
Internal SCLK/TCLK= XTAL operation limited to a
maximum of 4 MHz - 250 ns cycle time, when Low EMI
Oscillator is selected and system clock (SCLK = XTAL,
SMR Reg. Bit D1 =1).
Note for emulation only:
Do not set the emulator to emulate Port 1 in low EMI
mode. Port 1 must always be configured in Standard
Mode.
P0 HS
R/D
D/R
P1 HS
D/R
D/R
R/D
R/D
Z8 4K OTP Microcontroller
P2 HS
Z86E30/E31/E40
/DM
Ext
31
1