AM79C978 Advanced Micro Devices, AM79C978 Datasheet - Page 138
AM79C978
Manufacturer Part Number
AM79C978
Description
Single-Chip 1/10 Mbps PCI Home Networking Controller
Manufacturer
Advanced Micro Devices
Datasheet
1.AM79C978.pdf
(261 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Part Number:
AM79C978AKC/W
Manufacturer:
AMD
Quantity:
20 000
Company:
Part Number:
AM79C978AKCW
Manufacturer:
AMD
Quantity:
6 605
- Current page: 138 of 261
- Download datasheet (4Mb)
CSR78: Transmit Ring Length
Bit
31-16 RES
15-0
CSR80: DMA Transfer Counter and FIFO Threshold
Control
Bit
31-16 RES
15-14 RES
13-12 RCVFW[1:0] Receive
138
XMTRL
Name
Name
Reserved locations. Written as
zeros and read as undefined.
Transmit Ring Length. Contains
the two’s complement of the
transmit descriptor ring length.
This register is initialized during
the Am79C978 controller’s initial-
ization routine based on the value
in the TLEN field of the initializa-
tion block. However, this register
can be manually altered. The ac-
tual transmit ring length is defined
by the current value in this regis-
ter. The ring length can be de-
fined as any value from 1 to
65535.
Reserved locations. Written as
zeros and read as undefined.
Reserved locations. Written as
zeros and read as undefined.
RCVFW controls the point at
which receive DMA is requested
in relation to the number of re-
ceived bytes in the Receive FIFO.
RCVFW specifies the number of
bytes which must be present
(once the frame has been verified
as a non-runt) before receive
DMA is requested. Note, howev-
er, that if the network interface is
operating in half-duplex mode, in
order for receive DMA to be per-
formed for a new frame at least
64 bytes must have been re-
ceived. This effectively avoids
having to react to receive frames
which are runts or suffer a colli-
sion during the slot time (512 bit
times). If the Runt Packet Accept
feature is enabled or if the net-
These bits are read/write acces-
sible only when either the STOP
or the SPND bit is set. These bits
are unaffected by H_RESET,
S_RESET, or STOP.
Description
Description
FIFO
Watermark.
Am79C978
11-10 XMTSP[1:0] Transmit Start Point. XMTSP
Table 32. Receive Watermark Programming
RCVFW[1:0]
00
01
10
11
work interface is operating in full-
duplex mode, receive DMA will
be requested as soon as either
the RCVFW threshold is reached
or a complete valid receive frame
is detected (regardless of length).
When the FDRPAD (BCR9, bit 2)
is set and the Am79C978 control-
ler is in full-duplex mode, in order
for receive DMA to be performed
for a new frame at least 64 bytes
must have been received. This
effectively disables the runt pack-
et accept feature in full duplex.
When operating in the NO-SRAM
mode (no SRAM enabled), the
Bus Receive FIFO and the MAC
Receive operate like a single
FIFO and the watermark value
selected by RCVFW[1:0] sets the
number of bytes that must be
present in the FIFO before re-
ceive DMA is requested.
When operating with the SRAM,
the Bus Receive FIFO, and the
MAC Receive FIFO operate inde-
pendently on the bus side and
MAC side of the SRAM, respec-
tively. In this case, the watermark
value set by RCVFW[1:0] sets the
number of bytes that must be
present in the Bus Receive FIFO
only. See Table 32.
These bits are read/write acces-
sible only when either the STOP
or
RCVFW[1:0] is set to a value of
01b (64 bytes) after H_RESET or
S_RESET and is unaffected by
STOP.
controls the point at which pream-
ble transmission attempts to com-
mence in relation to the number
of bytes written to the MAC
Transmit FIFO for the current
the
Bytes Received
SPND
Reserved
112
16
64
bit
is
set.
Related parts for AM79C978
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
Advanced Micro Devices [4,096-Bit (512x8) Bipolar PROM]
Manufacturer:
Advanced Micro Devices
Datasheet:
Part Number:
Description:
Advanced Micro Devices [4,096-Bit (512x8) Bipolar PROM]
Manufacturer:
Advanced Micro Devices
Datasheet:
Part Number:
Description:
Advanced Micro Devices [8 Megabit (512 K x 16-Bit) CMOS 3.0 Volt-only Burst Mode Flash Memory]
Manufacturer:
Advanced Micro Devices
Datasheet:
Part Number:
Description:
M41000001YAdvanced Micro Devices [32 Megabit (4 M x 8-Bit/2 M x 16-Bit) CMOS 3.0 Volt-only, Simultaneous Operation Flash Memory and 4 Mbit (512 K x 8-Bit/256 K x 16-Bit) Static RAM]
Manufacturer:
Advanced Micro Devices
Datasheet:
Part Number:
Description:
Advanced Burst Error Processor
Manufacturer:
Advanced Micro Devices
Part Number:
Description:
Serial interface adapter (SIA)
Manufacturer:
Advanced Micro Devices
Datasheet:
Part Number:
Description:
Universal interrupt controller
Manufacturer:
Advanced Micro Devices
Datasheet:
Part Number:
Description:
256 kilobit CMOS EPROM
Manufacturer:
Advanced Micro Devices
Datasheet:
Part Number:
Description:
2048 x 8 static RAM, 100ns
Manufacturer:
Advanced Micro Devices
Datasheet:
Part Number:
Description:
Manufacturer:
Advanced Micro Devices
Datasheet:
Part Number:
Description:
Three-State Octal Buffers
Manufacturer:
Advanced Micro Devices
Datasheet:
Part Number:
Description:
AM2966PCOctal Dynamic Memory Drivers with Three-State Outputs
Manufacturer:
Advanced Micro Devices
Datasheet:
Part Number:
Description:
Three-State Octal Buffers
Manufacturer:
Advanced Micro Devices
Datasheet:
Part Number:
Description:
Three-State Octal Buffers
Manufacturer:
Advanced Micro Devices
Datasheet:
Part Number:
Description:
TTL programmable array logic, 7ns
Manufacturer:
Advanced Micro Devices
Datasheet: