LA-ISPPAC-POWR1014 LATTICE [Lattice Semiconductor], LA-ISPPAC-POWR1014 Datasheet - Page 14

• Manufacturer Part Number: LA-ISPPAC-POWR1014
• Description: In-System Programmable Power Supply Supervisor, Reset Generator and Sequencing Controller
• Manufacturer: LATTICE [Lattice Semiconductor]

Lattice Semiconductor
Figure 5-7. LA-ispPAC-POWR1014/A Voltage Monitors
Figure 5-7 shows the functional block diagram of one of the 10 voltage monitor inputs - ‘x’ (where x = 1...10). Each
voltage monitor can be divided into three sections: Analog Input, Window Control, and Filtering.
The voltage input is monitored by two individually programmable trip-point comparators, shown as CompA and
CompB. Table 5-1 shows all trip points and the range to which any comparator’s threshold can be set.
Each comparator outputs a HIGH signal to the PLD array if the voltage at its positive terminal is greater than its pro-
grammed trip point setting, otherwise it outputs a LOW signal.
A hysteresis of approximately 1% of the setpoint is provided by the comparators to reduce false triggering as a
result of input noise. The hysteresis provided by the voltage monitor is a function of the input divider setting.
Table 5-3 lists the typical hysteresis versus voltage monitor trip-point.
AGOOD Logic Signal
All the VMON comparators auto-calibrate immediately after a power-on reset event. During this time, the digital
glitch filters are also initialized. This process completion is signalled by an internally generated logic signal:
AGOOD. All logic using the VMON comparator logic signals must wait for the AGOOD signal to become active.
Programmable Over-Voltage and Under-Voltage Thresholds
Figure 5-8 (a) shows the power supply ramp-up and ramp-down voltage waveforms. Because of hysteresis, the
comparator outputs change state at different thresholds depending on the direction of excursion of the monitored
power supply.
VMONx
Trip Point A
Trip Point B
Analog Input
+
–
+
–
LA-ispPAC-POWR1014/A
Comp A
Comp B
LA-ispPAC-POWR1014/A Automotive Family Data Sheet
5-14
Window Control
Comp A/Window
Select
Glitch
Glitch
Filter
Filter
Filtering
VMONxA
Signal
Logic
VMONxB
Signal
Logic
POWR1014A only)
Unit (LA-ispPAC-
VMONx Status
I
To ADC
(LA-ispPAC-POWR1014A on
2
C Interface
Array
PLD