AT86RF230_09 ATMEL [ATMEL Corporation], AT86RF230_09 Datasheet - Page 62
AT86RF230_09
Manufacturer Part Number
AT86RF230_09
Description
Low Power 2.4 GHz Transceiver for ZigBee, IEEE 802.15.4, 6LoWPAN, RF4CE and ISM
Manufacturer
ATMEL [ATMEL Corporation]
Datasheet
1.AT86RF230_09.pdf
(98 pages)
- Current page: 62 of 98
- Download datasheet (2Mb)
9.4 Voltage Regulators (AVREG, DVREG)
9.4.1 Overview
62
AT86RF230
the SPI transfer rate shall be lower than 250 Kbit/s to ensure no TRX_UR interrupt
occurs.
Note, during the Frame Buffer read access the TRX_UR interrupt is first valid 64 µs
after the RX_START interrupt. The occurrence of the interrupt can be disregarded when
reading the first byte of the Frame Buffer between 32 µs and 64 µs after the
RX_START interrupt.
If a received frame upload is delayed and during the upload process a new frame is
received, a TRX_UR and an RX_START interrupt occurs. Even so, the old frame data
can be read, if the SPI data rate is higher than the effective over air data rate. A
minimum SPI clock rate of 1 MHz is recommended in this special case. Finally it is
required to check the uploaded frame data integrity by a FCS using the microcontroller.
When writing data to the Frame Buffer during frame transmission, the SPI transfer rate
shall be higher than 250 Kbit/s to ensure no TRX_UR interrupt occurs. The first byte of
the PSDU data must be available in the Frame Buffer before SFD transmission has
been completed, which takes 176 µs (16 µs PA ramp up + 128 µs preamble
transmission + 32 µs SFD transmission) from the rising edge of SLP_TR pin (see
Figure 7-2).
The main features of the Voltage Regulator modules are:
• Bandgap stabilized 1.8V supply for analog and digital domain.
• Low dropout (LDO) voltage regulator
• Configurable for usage of external voltage regulator
The internal voltage regulators supply the low voltage domains of the AT86RF230. The
AVREG provides the regulated 1.8V supply voltage for the analog section and the
DVREG supplies the 1.8V supply voltage for the digital section. A simplified schematic
of the internal voltage regulator is shown in Figure 9-2.
Figure 9-2. Simplified Schematic of AVREG/DVREG
reference
Bandgap
voltage
1.25V
DEVDD / EVDD
DVDD / AVDD
5131E-MCU Wireless-02/09
Related parts for AT86RF230_09
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
Atmel CryptoMemory
Manufacturer:
ATMEL [ATMEL Corporation]
Datasheet:
Part Number:
Description:
Atmel CryptoMemory
Manufacturer:
ATMEL [ATMEL Corporation]
Datasheet:
Part Number:
Description:
Atmel CryptoMemory, 16Kbit
Manufacturer:
ATMEL [ATMEL Corporation]
Datasheet:
Part Number:
Description:
8-bit Atmel Microcontrollers
Manufacturer:
ATMEL [ATMEL Corporation]
Datasheet:
Part Number:
Description:
8-bit Atmel Microcontroller with 64K/128K/256K Bytes In-System Programmable Flash
Manufacturer:
ATMEL [ATMEL Corporation]
Datasheet:
Part Number:
Description:
8-bit Atmel Microcontroller with 16/32/64/128K Bytes In-System Programmable Flash
Manufacturer:
ATMEL [ATMEL Corporation]
Datasheet:
Part Number:
Description:
8-bit Atmel Microcontroller with 16/32/64K Bytes In-System Programmable Programmable
Manufacturer:
ATMEL [ATMEL Corporation]
Datasheet:
Part Number:
Description:
INTERVAL AND WIPE/WASH WIPER CONTROL IC WITH DELAY
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
Low-Voltage Voice-Switched IC for Hands-Free Operation
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
MONOLITHIC INTEGRATED FEATUREPHONE CIRCUIT
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
AM-FM Receiver IC U4255BM-M
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
Monolithic Integrated Feature Phone Circuit
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
Multistandard Video-IF and Quasi Parallel Sound Processing
Manufacturer:
ATMEL Corporation
Datasheet: