BT8375 CONEXANT [Conexant Systems, Inc], BT8375 Datasheet - Page 45
![no-image](/images/no-image-200.jpg)
BT8375
Manufacturer Part Number
BT8375
Description
single chip transceivers for T1/E1 and Integrated Service Digital Network (ISDN) primary rate interfaces
Manufacturer
CONEXANT [Conexant Systems, Inc]
Datasheet
1.BT8375.pdf
(323 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
- Current page: 45 of 323
- Download datasheet (2Mb)
Bt8370/8375/8376
Fully Integrated T1/E1 Framer and Line Interface
2.4.4 Error Monitor
N8370DSE
The following signal errors are detected in the RCVR: Frame Bit Error (FERR),
MFAS Error (MERR), CAS Error (SERR), CRC Error (CERR), and Pulse
Density Violations (PDVs). Each error type has an interrupt enable bit that allows
an interrupt to occur marking the event, and has an interrupt register bit read by
the interrupt service routine. All error status registers are reset on read unless the
LATCH_ERR bit is set in the Alarm/Error/Counter Latch Configuration register
[LATCH; addr 046]. LATCH_ERR enables the 1-second latching of alarms
coincident with the 1-second timer interrupt [ISR6; addr 005]. With
LATCH_ERR enabled, any error detected during the 1-second interval is latched
and held during the following 1-second interval. LATCH_ERR allows the
processor to gather error statistics based on the 1-second interval.
[ISR5; addr 006] and for the transmit direction in Pattern Interrupt Status [ISR0;
addr 00B]. FERR indicates that 1 or more Ft/Fs/FPS frame bit errors or FAS
pattern errors occurred since the last time the interrupt status was read. The FERR
type is determined by the receive framer’s configuration [CR0; address 001].
in the Error Interrupt Status register [ISR5; addr 006] and for the transmit
direction in Pattern Interrupt Status [ISR0; addr 00B]. MERR is only applicable
in E1 mode and indicates that 1 or more MFAS pattern errors occurred since the
last time the interrupt status was read.
the Error Interrupt Status register [ISR5; addr 006] and for the transmit direction
in Pattern Interrupt Status [ISR0; addr 00B]. SERR is applicable only in E1 mode.
In this mode, SERR indicates that 1 or more errors were received in the TS16
Multiframe Alignment Signal (MAS) since the last time the interrupt status was
read.
[ISR5; addr 006] and for the transmit direction in Pattern Interrupt Status [ISR0;
addr 00B]. CERR is only applicable in T1 ESF and E1 MFAS modes. In these
modes, CERR indicates that 1 or more bit errors were found in the CRC4/CRC6
pattern block since the last time the interrupt status was read.
requirements of ANSI T1.403-1995 (Section 5.6). A PDV is declared whenever
more than 15 consecutive zeros or the average ones density falls below 12.5%.
RPDV is reported for the receive direction in the Alarm 1 Interrupt Status register
[ISR7; addr 004].
FERR is reported for the receive direction in the Error Interrupt Status register
While CRC4 framing is enabled, MERR is reported for the receive direction
While CAS framing is enabled, SERR is reported for the receive direction in
CERR is reported for the receive direction in the Error Interrupt Status register
PDV is reported when the receive signal does not meet the pulse density
Conexant
2.0 Circuit Description
2.4 Receiver
2-17
Related parts for BT8375
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
![RN41XVU-I/RM](/images/no-image3.png)
Part Number:
Description:
bt class 1 socket module w/ufl conn rn41-i/rm module...
Manufacturer:
Microchip
Datasheet:
![FM336PLUS-D](/images/no-image3.png)
Part Number:
Description:
V.34/Group 3 High Performance Fax Modem Family
Manufacturer:
CONEXANT [Conexant Systems, Inc]
Datasheet:
![DS96-L147-203](/images/no-image3.png)
Part Number:
Description:
SmartV.XX Modem
Manufacturer:
CONEXANT [Conexant Systems, Inc]
Datasheet:
![CX24123](/images/no-image3.png)
Part Number:
Description:
Demodulator and FEC Decoder Low-power QPSK demodulator for worldwide satellite set-top box applications
Manufacturer:
CONEXANT [Conexant Systems, Inc]
Datasheet:
![CX24130](/images/no-image3.png)
Part Number:
Description:
Dual Stream QPSK/BPSK Demodulator lC
Manufacturer:
CONEXANT [Conexant Systems, Inc]
Datasheet:
![CX24143](/images/no-image3.png)
Part Number:
Description:
Single-Chip FTA and FTA-CI Set-Top Box System Solution
Manufacturer:
CONEXANT [Conexant Systems, Inc]
Datasheet:
![CX24160](/images/no-image3.png)
Part Number:
Description:
Dual Digital Broadcast MPEG-2 Standard Definition TV Decoder with PVR Support
Manufacturer:
CONEXANT [Conexant Systems, Inc]
Datasheet:
![CX24170](/images/no-image3.png)
Part Number:
Description:
Digital Broadcast High-Definition TV Decoder with PVR Support
Manufacturer:
CONEXANT [Conexant Systems, Inc]
Datasheet:
![CX24183](/images/no-image3.png)
Part Number:
Description:
MPEG-4 AVC/H.264 Video Decoder
Manufacturer:
CONEXANT [Conexant Systems, Inc]
Datasheet:
![CX2427X](/images/no-image3.png)
Part Number:
Description:
Dual Decode HDTV MPEG-2/H.264/VC-1 Video Decoder
Manufacturer:
CONEXANT [Conexant Systems, Inc]
Datasheet:
![BT8954](/images/no-image3.png)
Part Number:
Description:
VOICE PAIR GAIN FRAMER
Manufacturer:
CONEXANT [Conexant Systems, Inc]
Datasheet:
![CX28331-1X](/images/no-image3.png)
Part Number:
Description:
Single/Dual/Triple E3/DS3/STS-1 Line Interface Unit
Manufacturer:
CONEXANT [Conexant Systems, Inc]
Datasheet:
![BT8222EPFF](/images/no-image3.png)
Part Number:
Description:
ATM Transmitter/Receiver with UTOPIA Interface
Manufacturer:
CONEXANT [Conexant Systems, Inc]
Datasheet:
![FM336PLUS-D](/images/no-image3.png)
Part Number:
Description:
V.34/Group 3 High Performance Fax Modem Family
Manufacturer:
CONEXANT [Conexant Systems, Inc]
Datasheet:
![DS96-L147-203](/images/no-image3.png)
Part Number:
Description:
SmartV.XX Modem
Manufacturer:
CONEXANT [Conexant Systems, Inc]
Datasheet: