CH7008A-V ETC [List of Unclassifed Manufacturers], CH7008A-V Datasheet - Page 24
![no-image](/images/no-image-200.jpg)
CH7008A-V
Manufacturer Part Number
CH7008A-V
Description
Digital PC to TV Encoder Features
Manufacturer
ETC [List of Unclassifed Manufacturers]
Datasheet
1.CH7008A-V.pdf
(49 pages)
CHRONTEL
Transfer Protocols (continued)
AutoInc
AR[5:0]
The following two sections describe the operation of the serial interface for the four combinations of R/W = 0,1 and
AutoInc = 0,1.
CH7008 Write Cycle Protocols (R/W = 0)
Data transfer with acknowledge is required. The acknowledge-related clock pulse is generated by the master-
transmitter. The master-transmitter releases the SD line (HIGH) during the acknowledge clock pulse. The slave-
receiver must pull down the SD line, during the acknowledge clock pulse, so that it remains stable LOW during the
HIGH period of the clock pulse. The CH7008 always acknowledges for writes (see Figure 19). Note that the
resultant state on SD is the wired-AND of data outputs from the transmitter and receiver.
Figure 20 shows two consecutive alternating write cycles for AutoInc = 0 and R/W = 0. The byte of information,
following the Register Address Byte (RAB), is the data to be written into the register specified by AR[5:0]. If
AutoInc = 0, then another RAB is expected from the master device, followed by another data byte, and so on.
24
Register Address Auto-Increment - to facilitate sequential R/W of registers.
“1”:
Write: After writing data into a register, the Address Register will automatically be
Read: Before loading data from a register to the on-chip temporary register (getting ready to
“0”:
Write: After writing data into a register, the Address Register will remain unchanged until a
Read: Before loading data from a register to the on-chip temporary register (getting ready to
Specifies the Address of the Register to be Accessed.
This register address is loaded into the Address Register of the CH7008. The R/W access, which
follows, is directed to the register specified by the content stored in the Address Register.
By Master-Transmitter
Auto-Increment enabled (auto-increment mode).
incremented by one.
be serially read), the Address Register will automatically be incremented by one.
However, for the first read after an RAB, the Address Register will not be changed.
Auto-Increment disabled (alternating mode).
new RAB is written.
be serially read), the Address Register will remain unchanged.
SD Data Output
SD Data Output
By the CH7008
Figure 19: Acknowledge on the Bus
SC from
Master
Condition
Start
1
2
not acknowledge
acknowledge
201-0000-027 Rev 2.2, 9/30/99
acknowledgment
8
clock pulse for
9
CH7008A