WT11i-E-AI4 Bluegiga Technologies, WT11i-E-AI4 Datasheet - Page 21

• Manufacturer Part Number: WT11i-E-AI4
• Description: Bluetooth / 802.15.1 Modules WT11i Class1 2.1+EDR uFL Conn iWRAP 4
• Manufacturer: Bluegiga Technologies

Specifications of WT11i-E-AI4

• Rohs: yes
• Class: 1
• Sensitivity: - 83 dBm
• Operating Supply Voltage: 3.3 V
• Interface Type: UART, USB
• Antenna Connector Type: Chip
• Maximum Operating Temperature: + 85 C
• Dimensions: 35.75 mm x 14.5 mm x 2.6 mm
• Mounting Style: SMD/SMT

Figure 12: USB_Detach and USB_Wake_Up Signals
7.8 USB Driver
A USB Bluetooth device driver is required to provide a software interface between BlueCore4-External and
Bluetooth software running on the host computer. Please, contact
[e-mail]
for suitable drivers.
7.9 USB v2.0 Compliance and Compatibility
Although WT11i meets the USB specification, CSR cannot guarantee that an application circuit designed
around the module is USB compliant. The choice of application circuit, component choice and PCB layout all
affect USB signal quality and electrical characteristics. The information in this document is intended as a guide
and should be read in association with the USB specification, with particular attention being given to Chapter
7. Independent USB qualification must be sought before an application is deemed USB compliant and can
bear the USB logo. Such qualification can be obtained from a USB plugfest or from an independent USB test
house.
Terminals USB_DP and USB_DN adhere to the USB Specification v2.0 (Chapter 7) electrical requirements.
BlueCore4-External is compatible with USB v2.0 host controllers; under these circumstances the two ends
agree the mutually acceptable rate of 12Mbits/s according to the USB v2.0 specification.
Bluegiga Technologies Oy
Page 21 of 38