WT11i-E-AI4 Bluegiga Technologies, WT11i-E-AI4 Datasheet - Page 32

• Manufacturer Part Number: WT11i-E-AI4
• Description: Bluetooth / 802.15.1 Modules WT11i Class1 2.1+EDR uFL Conn iWRAP 4
• Manufacturer: Bluegiga Technologies

Specifications of WT11i-E-AI4

• Rohs: yes
• Class: 1
• Sensitivity: - 83 dBm
• Operating Supply Voltage: 3.3 V
• Interface Type: UART, USB
• Antenna Connector Type: Chip
• Maximum Operating Temperature: + 85 C
• Dimensions: 35.75 mm x 14.5 mm x 2.6 mm
• Mounting Style: SMD/SMT

12 Certifications
WT11i-E is compliant to the following specifications. At the time of writing this version the official approval for
these specifications is still in the process. Immediately when Bluegiga has received the approval this
disclaimer is removed and the new version of this document is published.
12.1 Bluetooth
WT11i-E module is Bluetooth qualified and listed as a controller subsystem and it is Bluetooth compliant to the
following profiles of the core spec version 2.1/2.1+EDR.
12.2 FCC and IC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
FCC RF Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End
users must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter
must not be co-located or operating in conjunction with any other antenna or transmitter. This transmitter is
considered as mobile device and should not be used closer than 20 cm from a human body. To allow portable
use in a known host class 2 permissive change is required. Please contact
information.
IC Statements:
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and
maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio
interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically
radiated power (e.i.r.p.) is not more than that necessary for successful communication.




(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
Baseband
HCI
Link Manager
Radio
Bluegiga Technologies Oy
[e-mail]
Page 32 of 38
for detailed