MPC8308VMAFDA Freescale Semiconductor, MPC8308VMAFDA Datasheet - Page 5

• Manufacturer Part Number: MPC8308VMAFDA
• Description: Microprocessors - MPU E300 MP PbFr 333
• Manufacturer: Freescale Semiconductor

Specifications of MPC8308VMAFDA

• Rohs: yes
• Processor Series: MPC8308
• Core: e300
• Maximum Clock Frequency: 333 MHz
• Interface Type: I2C, JTAG, UART
• Operating Supply Voltage: 0.95 V to 1.05 V
• Maximum Operating Temperature: 0 C to + 105 C
• Mounting Style: SMD/SMT
• Package / Case: MAPBGA-473

This figure shows the undershoot and overshoot voltages at the interfaces of the device.
2.1.3
This table provides information on the characteristics of the output driver strengths.
2.1.4
It is required to apply the core supply voltage (V
NV
to 90% of its nominal value before the I/O supplies reach 0.7 V; see
If this recommendation is not observed and I/O voltages are supplied before the core voltage, there might
be a period of time that all input and output pins are actively driven and cause contention and excessive
current. To overcome side effects of this condition, the application environment may require tuning of
external pull-up or pull-down resistors on particular signals to lesser values.
Freescale Semiconductor
DD
1
Local bus interface utilities signals
DDR2 signals
DUART, system control, I
eTSEC signals
) and assert PORESET before the power supplies fully ramp up. The core voltage supply must rise
Output Impedance can also be adjusted through configurable options in DDR Control Driver Register (DDRCDR).
For more information, see the MPC8308 PowerQUICC II Pro Processor Reference Manual.
Output Driver Characteristics
Power Sequencing
V
V
Note:
IH
1. t
IL
1
interface
G/L/NV
G/L/NV
MPC8308 PowerQUICC II Pro Processor Hardware Specification, Rev. 3
Figure 2. Overshoot/Undershoot Voltage for GVDD/NVDD/LVDD
VSS – 0.3 V
VSS – 0.7 V
refers to the clock period associated with the bus clock interface.
G/L/NV
DD
DD
Driver Type
2
C, JTAG, eSDHC, GPIO,SPI, USB
+ 20%
+ 5%
VSS
DD
Table 3. Output Drive Capability
DD
Not to Exceed 10%
) before the I/O supply voltages (GV
of t
interface
Output Impedance ()
1
42
18
42
42
Figure
3.
LV
Supply Voltage
NV
GV
NV
DD
Electrical Characteristics
DD
DD
DD
= 2.5/3.3 V
DD
= 3.3 V
= 3.3 V
= 1.8 V
, LV
DD
, and
5