CL8801K6-G Supertex, CL8801K6-G Datasheet - Page 6

• Manufacturer Part Number: CL8801K6-G
• Description: LED Lighting Drivers SEQUENTIAL LED DRVR 13W
• Manufacturer: Supertex

Specifications of CL8801K6-G

• Rohs: yes
• Maximum Supply Current: 410 uA
• Output Current: 200 mA
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Package / Case: QFN-40
• Minimum Operating Temperature: - 40 C
• Power Dissipation: 13 W

Pin Description
Note:
Doc.# DSFP-CL8801
B121712
19 - 20
22 - 26
The high voltage pins are located on one side of the package and are arranged from lowest voltage to highest. Pin-to-pin voltage gradients are mini-
mized.
Pin #
Underside plate
1 - 8
10
12
13
14
15
16
17
18
21
27
28
29
30
31
32
33
11
9
(GND)
Name
SET1
SET2
SET3
SET4
TAP4
TAP3
TAP2
TAP1
BIAS
GND
GND
GND
GND
Pin
NC
NC
NC
NC
NC
NC
NC
NC
Description
Circuit common (use for heat sink ground plane pass through).
Current sense for linear current regulators for each tap. Resistors on these pins sets the tap currents.
No internal connection.
Current sense for linear current regulators for each tap. Resistors on these pins sets the tap currents.
No internal connection.
Current sense for linear current regulators for each tap. Resistors on these pins sets the tap currents.
No internal connection.
No internal connection.
No internal connection.
Current sense for linear current regulators for each tap. Resistors on these pins sets the tap currents.
No internal connection.
Circuit common (use for heat sink ground plane pass through).
Circuit common. Connect to bridge rectifier return (use for heat sink ground plane pass through).
Circuit common (use for heat sink ground plane pass through).
Current regulator outputs. Connect to taps along the LED string.
No internal connection.
Current regulator outputs. Connect to taps along the LED string.
No internal connection.
Current regulator outputs. Connect to taps along the LED string.
Current regulator outputs. Connect to taps along the LED string.
Provides bias for driver. Connect to rectified AC.
For heatsinking purposes, it should be soldered to a 4.0cm
be electrically connected to circuit common (GND).
6
2
exposed copper area. It should also
Supertex inc.
www.supertex.com
CL8801