L6472H STMicroelectronics, L6472H Datasheet - Page 54

• Manufacturer Part Number: L6472H
• Description: Motor / Motion / Ignition Controllers & Drivers Motor DRV SPI dSPIN 7.0A 3.0 rms 8 - 45V
• Manufacturer: STMicroelectronics
• Type: 2 Phase Stepper Motor Driverr

Specifications of L6472H

• Product Category: Motor / Motion / Ignition Controllers & Drivers
• Rohs: yes
• Product: Stepper Motor Controllers / Drivers
• Operating Supply Voltage: 8 V to 45 V
• Supply Current: 0.5 mA
• Operating Temperature: - 25 C to + 125 C
• Mounting Style: SMD/SMT
• Package / Case: HTSSOP-28
• Power Dissipation: 5 W

Programming manual
9.2.1
9.2.2
54/68
Command management
The host microcontroller can control motor motion and configure the L6472 through a
complete set of commands.
All commands are composed by a single byte. After the command byte, some argument
bytes should be needed (see
Figure 22. Command with 3-byte argument
By default the device returns an all zero response for any received byte, the only exceptions
are GetParam and GetStatus commands. When one of these commands is received the
following response bytes represent the related register value (see
Response length can vary from 1 to 3 bytes.
Figure 23. Command with 3-byte response
During response transmission, new commands can be sent. If a command requiring a
response is sent before the previous response is completed, the response transmission is
aborted and the new response is loaded into the output communication buffer (see
Figure
Figure 24. Command response aborted
When a byte that does not correspond to a command is sent to the IC, it is ignored and the
WRONG_CMD flag in the STATUS register is raised (see
Nop
Table 35.
Nothing is performed.
Bit 7
0
24).
Bit 6
NOP command structure
0
Bit 5
0
Figure
Doc ID 022729 Rev 2
Bit 4
0
22). Argument length can vary from 1 to 3 bytes.
Bit 3
0
Bit 2
0
Section
Bit 1
0
9.1.19).
Figure
Bit 0
0
23).
From host
L6472