ST72T213G1B6 STMicroelectronics, ST72T213G1B6 Datasheet - Page 44

• Manufacturer Part Number: ST72T213G1B6
• Description: 8-bit Microcontrollers - MCU OTP EPROM 4K SPI
• Manufacturer: STMicroelectronics

Specifications of ST72T213G1B6

• Rohs: yes
• Core: ST7
• Data Bus Width: 8 bit
• Maximum Clock Frequency: 8 MHz
• Program Memory Size: 4 KB
• Data Ram Size: 256 B
• On-chip Adc: Yes
• Operating Supply Voltage: 3 V to 5.5 V
• Package / Case: PDIP-32
• Mounting Style: Through Hole
• A/d Bit Size: 8 bit
• A/d Channels Available: 6
• Interface Type: SPI
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Number Of Programmable I/os: 22
• Number Of Timers: 1
• On-chip Dac: No
• Program Memory Type: OTP EPROM
• Factory Pack Quantity: 16
• Supply Voltage - Max: 5.5 V
• Supply Voltage - Min: 3.5 V

ST72101/ST72212/ST72213
16-BIT TIMER (Cont’d)
5.3.4 Low Power Modes
5.3.5 Interrupts
Note: The 16-bit Timer interrupt events are connected to the same interrupt vector (see Interrupts chap-
ter). These events generate an interrupt if the corresponding Enable Control Bit is set and the interrupt
mask in the CC register is reset (RIM instruction).
5.3.6 Summary of Timer modes
1)
2)
3)
44/85
WAIT
HALT
Input Capture 1 event/Counter reset in PWM mode
Input Capture 2 event
Output Compare 1 event (not available in PWM mode)
Output Compare 2 event (not available in PWM mode)
Timer Overflow event
Input Capture (1 and/or 2)
Output Compare (1 and/or 2)
One Pulse mode
PWM Mode
See note 4 in
See note 5 in
See note 4 in
Mode
44
MODES
No effect on 16-bit Timer.
Timer interrupts cause the device to exit from WAIT mode.
16-bit Timer registers are frozen.
In HALT mode, the counter stops counting until Halt mode is exited. Counting resumes from the previous
count when the MCU is woken up by an interrupt with “exit from HALT mode” capability or from the counter
reset value when the MCU is woken up by a RESET.
If an input capture event occurs on the ICAP i pin, the input capture detection circuitry is armed. Consequent-
ly, when the MCU is woken up by an interrupt with “exit from HALT mode” capability, the ICF i bit is set, and
the counter value present when exiting from HALT mode is captured into the IC i R register.
Section 0.1.3.5 One Pulse Mode
Section 0.1.3.5 One Pulse Mode
Section 0.1.3.6 Pulse Width Modulation Mode
Interrupt Event
Input Capture 1
Yes
Yes
No
No
Not Recommended
Not Recommended
Input Capture 2
Description
AVAILABLE RESOURCES
Yes
Yes
1)
3)
Output Compare 1 Output Compare 2
Event
OCF1
OCF2
Flag
ICF1
ICF2
TOF
Yes
Yes
No
No
Control
Enable
OCIE
TOIE
ICIE
Bit
from
Wait
Exit
Yes
Yes
Yes
Yes
Yes
Partially
Yes
Yes
No
from
Exit
Halt
No
No
No
No
No
2)