ROBOT-M24LR16E-A STMicroelectronics, ROBOT-M24LR16E-A Datasheet
ROBOT-M24LR16E-A
Specifications of ROBOT-M24LR16E-A
Available stocks
Related parts for ROBOT-M24LR16E-A
ROBOT-M24LR16E-A Summary of contents
Page 1
... RF WIP/BUSY output with 20 kΩ pull-up resistor, to indicate that an RF operation is ongoing Description The ROBOT-M24LR16E ready-to-use PCB that features an M24LR16-R dual interface EEPROM IC connected to an I²C bus and 13.56 MHz etched RF antenna. It also features two LEDs, powered by the M24LR16E-R V pin and an output connector ...
Page 2
... Figure 1. Functional block diagram 2/5 Doc ID 022238 Rev 1 ROBOT-M24LR16E-A ...
Page 3
... ROBOT-M24LR16E-A 1 Associated firmware and PC software The ROBOT-M24LR16E-A is supported software, the Dual Interface EEPROM tool software, that allows to configure and control the energy harvesting. This software is available from http://www.st.com. Refer to application note AN3954 “Developing your own Visual Basic or C/C++ application on a DEMO-CR95HF-A demonstration board” ...
Page 4
... Revision history 3 Revision history Table 2. Document revision history Date 27-Sep-2011 4/5 Revision 1 Initial release. Doc ID 022238 Rev 1 ROBOT-M24LR16E-A Changes ...
Page 5
... ROBOT-M24LR16E-A Information in this document is provided solely in connection with ST products. STMicroelectronics NV and its subsidiaries (“ST”) reserve the right to make changes, corrections, modifications or improvements, to this document, and the products and services described herein at any time, without notice. All ST products are sold pursuant to ST’s terms and conditions of sale. ...