SPZB32W1A2.1 STMicroelectronics, SPZB32W1A2.1 Datasheet - Page 15

• Manufacturer Part Number: SPZB32W1A2.1
• Description: Zigbee / 802.15.4 Modules Zigbee PRO Module STM32W Chipset
• Manufacturer: STMicroelectronics

Specifications of SPZB32W1A2.1

• Product Category: Zigbee / 802.15.4 Modules
• Frequency Band: 2.4 GHz
• Sensitivity: - 95 dBm
• Operating Supply Voltage: 3.3 V
• Supply Current Transmitting: 32 mA
• Supply Current Receiving: 28 mA
• Output Power: 6 dBm
• Antenna Connector Type: Integrated
• Maximum Operating Temperature: + 85 C
• Dimensions: 26.5 mm x 16.4 mm x 3.9 mm
• Interface Type: I2C, UART
• Minimum Operating Temperature: - 40 C

SPZB32W1x2.1
9
9.1
Product approvals
These modules have been designed to meet national regulations for world wide use. In
particular the following certifications have been obtained
FCC approvals
The SPZB32W1A2.1 device, with integrated antenna, as well as the SPZB32W1C2.1, with
the antenna specified in
Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate, radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference can not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
●
●
●
Consult the dealer or an experienced radio/TV technician for help.
Module type: ZigBee
FCC-ID: S9NZB32C2
Modular type: single modular
Table 8.
Any changes or modifications not expressly approved by the part responsible for compliance
may cause the module to cease to comply with FCC rules part 15, and therefore render void
the user’s authority to operate the equipment.
While the applicant for a device into which the SPZB32W1A2.1 or the SPZB32W1C2.1 with
the antenna specified in
module, this does not preclude the possibility that some other form of authorization or
testing may be required for the end product.
ITEM
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment to an outlet on a circuit different from that to which the receiver
is connected
1
FCC approvals
®
module, SPZB32W1A2.1 / SPZB32W1C2.1
Table
2010B4844-01 (Titanis Antenna)
Table 8
Doc ID 018899 Rev 2
8, have been tested and found to comply with the limits for a
installed is not required to obtain new authorization for the
Part No.
Product approvals
Manufacturer
Antenova
15/19