MT29F4G08AAAWP:A TR Micron Technology Inc, MT29F4G08AAAWP:A TR Datasheet - Page 37
![IC FLASH 4GBIT 48TSOP](/photos/7/23/72302/micron_photo_-_mt29f2g__sml.jpg)
MT29F4G08AAAWP:A TR
Manufacturer Part Number
MT29F4G08AAAWP:A TR
Description
IC FLASH 4GBIT 48TSOP
Manufacturer
Micron Technology Inc
Datasheet
1.MT29F2G08AAAWP.pdf
(57 pages)
Specifications of MT29F4G08AAAWP:A TR
Format - Memory
FLASH
Memory Type
FLASH - Nand
Memory Size
4G (512M x 8)
Interface
Parallel
Voltage - Supply
2.7 V ~ 3.6 V
Operating Temperature
0°C ~ 70°C
Package / Case
48-TSOP
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Speed
-
Other names
557-1202-1
Error Management
PDF: 09005aef818a56a7 / Source: 09005aef81590bdd
2gb_nand_m29b__2.fm - Rev. I 1/06 EN
Micron NAND devices are specified to have a minimum of 2,008 (N
of every 2,048 total available blocks. This means the devices may have blocks that are
invalid when they are shipped. An invalid block is one that contains one or more bad
bits. Additional bad blocks may develop with use. However, the total number of avail-
able blocks will not fall below N
Although NAND memory devices may contain bad blocks, they can be used quite reli-
ably in systems that provide bad-block mapping, replacement, and error correction
algorithms. This type of software environment ensures data integrity.
Internal circuitry isolates each block from other blocks, so the presence of a bad block
does not affect the operation of the rest of the Flash device.
The first block (physical block address 00h) for each CE# in Micron NAND devices is
guaranteed to be free of defects (up to 1,000 PROGRAM/ERASE cycles) when shipped
from the factory. This provides a reliable location for storing boot code and critical boot
information.
Before NAND Flash devices are shipped from Micron, they are erased. The factory iden-
tifies invalid blocks before shipping by programming data other than FFh (x8) or FFFFh
(x16) into the first spare location (column address 2,048 for x8 devices, or 1,024 for x16
devices) of the first or second page of each bad block.
System software should check the first spare address on the first or second page of each
block prior to performing any erase or programming operations on the Flash device. A
bad block table can then be created, allowing system software to map around these
areas. Factory testing is performed under worst-case conditions. Because blocks marked
“bad” may be marginal, it may not be possible to recover this information if the block is
erased.
Over time, some memory locations may fail to program or erase properly. In order to
ensure that data is stored properly over the life of the Flash device, certain precautions
must be taken, such as:
• Always check status after a WRITE, ERASE, or DATA MOVE operation.
• Use some type of error detection and correction algorithm to recover from single-bit
• Use a bad-block replacement algorithm.
errors.
2, 4, 8Gb: x8/x16 Multiplexed NAND Flash Memory
37
VB
during the endurance life of the product.
Micron Technology, Inc., reserves the right to change products or specifications without notice.
©2004 Micron Technology, Inc. All rights reserved.
Error Management
VB
) valid blocks out